enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Rod end bearing - Wikipedia

   en.wikipedia.org/wiki/Rod_end_bearing

   A rod end bearing, also known as a heim joint (N. America) or rose joint (U.K. and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links, tie rods, or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect 90-degree alignment between the ...

3. Ball joint - Wikipedia

   en.wikipedia.org/wiki/Ball_joint

   A typical ball joint with cutaway view (right) An inner tie rod end cut open to expose the ball joint. In an automobile, ball joints are spherical bearings that connect the control arms to the steering knuckles, and are used on virtually every automobile made. [1] They bionically resemble the ball-and-socket joints found in most tetrapod ...

4. Steering linkage - Wikipedia

   en.wikipedia.org/wiki/Steering_linkage

   The steering linkage which connects the steering gearbox to the front wheels consists of a number of rods. These rods are connected with a socket arrangement similar to a ball joint, called a tie rod end, allowing the linkage to move back and forth freely so that the steering effort will not interfere with the vehicles up-and-down motion as the ...

5. Parallelogram steering linkage - Wikipedia

   en.wikipedia.org/wiki/Parallelogram_steering_linkage

   A parallelogram steering linkage is called such because like its namesake, the two sides of the linkage run parallel to each other and are equal in distance. This type of steering linkage uses four tie rods, one inner and one outer on each side (left and right) that are connected by an adjustment sleeve, a center link (which runs between the tie rods), an idler arm on the passenger side, and a ...

6. Drag link - Wikipedia

   en.wikipedia.org/wiki/Drag_link

   Steering system showing drag link. A drag link converts rotary motion from a crank arm, to a second bellcrank, usually in an automotive steering system.. While the origin of the term is not clear, it pre-dates the automobile, and is described as in use in 1849 as a means of rotating a Ducie cultivator being operated by cable by stationary steam engine (or between engines).

7. Crankpin - Wikipedia

   en.wikipedia.org/wiki/Crankpin

   This end of the connecting rod is called the "big end", as opposed to the "small end" or "little end" (which connects to the wrist/gudgeon pin in the piston). The bearing which allows the crankpin to rotate around its shaft is called the "rod bearing". [5] In automotive engines, the most common type of rod bearing is the plain bearing, however ...