Search results
Results from the WOW.Com Content Network
Thus, HFO is also commonly referred to as residual fuel oil. The chemical composition of HFO is highly variable due to the fact that HFO is often mixed or blended with cleaner fuels; blending streams can include carbon numbers from C 20 to greater than C 50. HFOs are blended to achieve certain viscosity and flow characteristics for a given use.
No. 5 fuel oil is also called Navy Special Fuel Oil (NSFO) or just navy special; No. 5 or 6 are also commonly called heavy fuel oil (HFO) or furnace fuel oil (FFO); the high viscosity requires heating, usually by a recirculated low pressure steam system, before the oil can be pumped from a bunker tank. Bunkers are rarely labeled this way in ...
Both CII and CCAI are calculated from the density and kinematic viscosity of the fuel. CII was developed by BP to calculate the autoignition capacity of heavy fuel oils (HFO). It is calculated using the measured kinematic viscosity V (cSt or mm 2 /s) of a given fuel determined at temperature t (°C) and the density ρ 15 at 15°C (kg/m 3). [1]
Printable version; In other projects ... Chemical structure of 1,3,3,3-tetrafluoropropene (HFO-1234ze ... heat recovery and medium temperature heat pumps. ...
Fuel oil's viscosity strongly depends on the temperature, the higher is the temperature the lower is the viscosity. For optimal combustion the viscosity of the fuel should be in the range of 10–20 cSt. To maintain this value a combination of viscometer, PID controller and heater is used. Viscometer measures the actual viscosity of the fuel ...
As the name suggests, CCAI is a calculation based on the density and viscosity of a given fuel. The formula is rather complex but in general, the higher the CCAI, the poorer the ignition quality of the fuel is considered to be. Once the CCAI goes above 860, it is an indication that some combustion problems may occur.
trans-1,3,3,3-Tetrafluoropropene (HFO-1234ze(E), R-1234ze(E)) is a hydrofluoroolefin.It was developed as a "fourth generation" refrigerant to replace fluids such as R-134a, as a blowing agent for foam and aerosol applications, and in air horns and gas dusters. [3]
Consequently, if a liquid has dynamic viscosity of n centiPoise, and its density is not too different from that of water, then its kinematic viscosity is around n centiStokes. For gas, the dynamic viscosity is usually in the range of 10 to 20 microPascal-seconds, or 0.01 to 0.02 centiPoise. The density is usually on the order of 0.5 to 5 kg/m^3.