Ads
related to: ham radio coax switchebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Various popular RF connectors Electronic symbols for the plug and jack coaxial connectors Time-domain reflectometry shows reflections due to impedance variations in mated RF connectors. An RF connector (radio frequency connector) is an electrical connector designed to work at radio frequencies in the multi-megahertz range.
[7] [4] It is a widely used standard connector for HF transmission lines on full-sized radio equipment, with BNC connectors predominating for smaller, hand-held equipment. [ 7 ] The name "UHF" is a source of confusion, since the name of the connectors did not change when the frequency ranges were renamed.
If a quarter-wavelength of 75 Ohm coaxial cable is linked to a 50 Ohm load, the SWR in the 75 Ohm quarter wavelength of line can be calculated as 75Ω / 50Ω = 1.5; the quarter-wavelength of line transforms the mismatched impedance to 112.5 Ohms (75 Ohms × 1.5 = 112.5 Ohms). Thus this inserted section matches a 112 Ohm antenna to a 50 Ohm main ...
With no matching unit, Varney specified 75 Ω cable be used at the junction of the ladder line and coax (not 50 Ω); the higher 75 Ω impedance makes a closer match the end of the ladder line. An earth-grounded 4:1 voltage balun may be used to connect the coax to the ladder line, and 1:1 current balun should be used between the coax and the ...
Repeater frequency sets are known as "repeater pairs", and in the ham radio community most follow ad hoc standards for the difference between the two frequencies, commonly called the offset. In the USA two-meter band, the standard offset is 600 kHz (0.6 MHz), but sometimes unusual offsets, referred to as oddball splits, are used. The actual ...
If a coil is made using coaxial cable near to the feed point of a balanced antenna, then the RF current that flows on the outer surface of the coaxial cable can be attenuated. One way of doing this would be to pass the cable through a ferrite toroid. The end result is exactly the same as a 1:1 current balun (or Guanella-type balun).
Ads
related to: ham radio coax switchebay.com has been visited by 1M+ users in the past month