Search results
Results from the WOW.Com Content Network
The Penman equation describes evaporation (E) from an open water surface, and was developed by Howard Penman in 1948. Penman's equation requires daily mean temperature, wind speed, air pressure, and solar radiation to predict E. Simpler Hydrometeorological equations continue to be used where obtaining such data is impractical, to give comparable results within specific contexts, e.g. humid vs ...
E = Mass water evapotranspiration rate (g s −1 m −2) ET = Water volume evapotranspired (mm s −1) Δ = Rate of change of saturation specific humidity with air temperature. (Pa K −1) R n = Net irradiance (W m −2), the external source of energy flux G = Ground heat flux (W m −2), usually difficult to measure c p = Specific heat ...
In the case of an equilibrium solid, such as a crystal, this can be defined as the pressure when the rate of sublimation of a solid matches the rate of deposition of its vapor phase. For most solids this pressure is very low, but some notable exceptions are naphthalene , dry ice (the vapor pressure of dry ice is 5.73 MPa (831 psi, 56.5 atm) at ...
The boiling point of water is the temperature at which the saturated vapor pressure equals the ambient pressure. Water supercooled below its normal freezing point has a higher vapor pressure than that of ice at the same temperature and is, thus, unstable. Calculations of the (saturation) vapor pressure of water are commonly used in meteorology.
In ecology, it is the difference between the water vapour pressure and the saturation water vapour pressure at a particular temperature. Unlike relative humidity, vapour-pressure deficit has a simple nearly straight-line relationship to the rate of evapotranspiration and other measures of evaporation.
Monthly estimated potential evapotranspiration and measured pan evaporation for two locations in Hawaii, Hilo and Pahala. Potential evapotranspiration is usually measured indirectly, from other climatic factors, but also depends on the surface type, such as free water (for lakes and oceans), the soil type for bare soil, and also the density and diversity of vegetation.
The Hertz–Knudsen equation describes the non-dissociative adsorption of a gas molecule on a surface by expressing the variation of the number of molecules impacting on the surfaces per unit of time as a function of the pressure of the gas and other parameters which characterise both the gas phase molecule and the surface: [1] [2]
Since evaporation ponds operate best with greater surface area of evaporation, large amount of land is required, so low quality, low cost land is better [2] A shallow pond covering greater surface area will result in faster rates of evaporation. [2] A view of evaporation ponds that are designed to extend for miles of land