Search results
Results from the WOW.Com Content Network
An evaporative cooler (also known as evaporative air conditioner, swamp cooler, swamp box, desert cooler and wet air cooler) is a device that cools air through the evaporation of water. Evaporative cooling differs from other air conditioning systems, which use vapor-compression or absorption refrigeration cycles.
Vacuum cooling is a rapid cooling technique for any porous product that has free water and uses the principle of evaporative cooling.Vacuum cooling is generally used for cooling food products that have a high water content and large porosities, due to its efficacy in losing water from both within and outside the products.
Evaporative emissions are the result of gasoline vapors escaping from the vehicle's fuel system. Since 1971, all U.S. vehicles have had fully sealed fuel systems that do not vent directly to the atmosphere; mandates for systems of this type appeared contemporaneously in other jurisdictions.
Demonstration of evaporative cooling. When the sensor is dipped in ethanol and then taken out to evaporate, the instrument shows progressively lower temperature as the ethanol evaporates. Rain evaporating after falling on hot pavement. Evaporation is a type of vaporization that occurs on the surface of a liquid as it changes into the gas phase. [1]
A pot-in-pot refrigerator, clay pot cooler [1] or zeer (Arabic: زير) is an evaporative cooling refrigeration device which does not use electricity. It uses a porous outer clay pot (lined with wet sand) containing an inner pot (which can be glazed to prevent penetration by the liquid) within which the food is placed. The evaporation of the ...
This system works very well in getting rid of crankcase vapors which are harmful to the engine. As per the earlier engines, the road draught tube system also created pollution and objectionable odors. [1] The draught tube could become clogged with snow or ice, in which case crankcase pressure would build and cause oil leaks and gasket failure. [2]
Since the cooling towers are based on the principles of evaporative cooling, the maximum cooling tower efficiency depends on the wet bulb temperature of the air. The wet-bulb temperature is a type of temperature measurement that reflects the physical properties of a system with a mixture of a gas and a vapor, usually air and water vapor
The vapor may be released from the system while the liquid may be recirculated through the evaporator to further concentrate the solute. In many cases, the tubes of a rising film evaporator are usually between 3–10 metres (9.8–32.8 ft) in height with a diameter of between 25–50 millimetres (0.98–1.97 in).