Search results
Results from the WOW.Com Content Network
A block diagram is a diagram of a system in which the principal parts or functions are represented by blocks connected by lines that show the relationships of the blocks. [1] They are heavily used in engineering in hardware design , electronic design , software design , and process flow diagrams .
An example of a closed-loop block diagram, from which a transfer function may be computed, is shown below: The summing node and the G(s) and H(s) blocks can all be combined into one block, which would have the following transfer function: () = + ()
Function Block Diagram is one of five languages for logic or control configuration [2] supported by standard IEC 61131-3 for a control system such as a programmable logic controller (PLC) or a Distributed Control System (DCS). The other supported languages are ladder logic, sequential function chart, structured text, and instruction list.
Functional block diagram of the attitude control and maneuvering electronics system of the Gemini spacecraft. June 1962. A functional block diagram, in systems engineering and software engineering, is a block diagram that describes the functions and interrelationships of a system. The functional block diagram can picture: [1]
Every control system must guarantee first the stability of the closed-loop behavior. For linear systems, this can be obtained by directly placing the poles. Nonlinear control systems use specific theories (normally based on Aleksandr Lyapunov's Theory) to ensure stability without regard to the inner dynamics of the system. The possibility to ...
A control loop is the fundamental building block of control systems in general and industrial control systems in particular. It consists of the process sensor, the controller function, and the final control element (FCE) which controls the process necessary to automatically adjust the value of a measured process variable (PV) to equal the value of a desired set-point (SP).
The control action is the switching on/off of the boiler, but the controlled variable should be the building temperature, but is not because this is open-loop control of the boiler, which does not give closed-loop control of the temperature. In closed loop control, the control action from the controller is dependent on the process output.
In a control-flow graph each node in the graph represents a basic block, i.e. a straight-line sequence of code with a single entry point and a single exit point, where no branches or jumps occur within the block. Basic blocks starts with jump targets and ends with jumps or branch instructions.