Search results
Results from the WOW.Com Content Network
The specific weight, also known as the unit weight (symbol γ, the Greek letter gamma), is a volume-specific quantity defined as the weight W divided by the volume V of a material: = / Equivalently, it may also be formulated as the product of density, ρ, and gravity acceleration, g: = Its unit of measurement in the International System of Units (SI) is newton per cubic metre (N/m 3), with ...
This also allows a comparison between the level of a given nutrient in dry matter and the level needed in an animal's diet. [10] Dry matter intake (DMI) refers to feed intake excluding its water content. The percentage of water is frequently determined by heating the feed on a paper plate in a microwave oven or using the Koster Tester to dry ...
TSS of a water or wastewater sample is determined by pouring a carefully measured volume of water (typically one litre; but less if the particulate density is high, or as much as two or three litres for very clean water) through a pre-weighed filter of a specified pore size, then weighing the filter again after the drying process that removes all water on the filter.
W water is the weight of the sample in water (measured in the same units). This technique cannot easily be used to measure relative densities less than one, because the sample will then float. W water becomes a negative quantity, representing the force needed to keep the sample underwater. Another practical method uses three measurements.
See Weight for detail of mass/weight distinction and conversion. Avoirdupois is a system of mass based on a pound of 16 ounces, while Troy weight is the system of mass where 12 troy ounces equals one troy pound. The symbol g 0 is used to denote standard gravity in order to avoid confusion with the (upright) g symbol for gram.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
Weight is measured in ounces and pounds (avoirdupois) as in the U.S. Volume is measured in imperial gallons, quarts, pints, fluid ounces, fluid drachms, and minims. The imperial gallon was originally defined as 10 pounds (4.5359 kg) of water in 1824, and refined as exactly 4.54609 litres in 1985.
For example, in a recipe that calls for 10 pounds of flour and 5 pounds of water, the corresponding baker's percentages are 100% for the flour and 50% for the water. Because these percentages are stated with respect to the weight of flour rather than with respect to the weight of all ingredients, the sum of these percentages always exceeds 100%.