enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ISO standards for trailer connectors - Wikipedia

   en.wikipedia.org/wiki/ISO_standards_for_trailer...

   7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.

3. Trailer connectors in North America - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   Flat 5-pin connector (Towing vehicle side) This contact is not as common, but is compatible with the 4-pin connector in the way that a towing vehicle with this connector can be connected to a trailer with the 4-pin flat plug. The extra connection is often used to block the surge brakes when reversing with the trailer. #

4. ISO 11446 - Wikipedia

   en.wikipedia.org/wiki/ISO_11446

   Ground for pin 9 [a] ISO 11446:2004 specifies a 13-pole electrical connector between towing and towed vehicles with 12 volt electrical system . It was developed in 1987 by Erich Jaeger [ 1 ] to replace older 7-pin plugs.

5. Trailer connector - Wikipedia

   en.wikipedia.org/wiki/Trailer_Connector

   A trailer connector is a multi-pole electrical connector between a towing vehicle (car, truck) and a trailer. It is intended primarily to supply automotive lighting on the trailer, but also provide management and supply to other loads. It is also referred to as "trailer wire," "trailer cable," or "trailer connecting cable."

6. Trailer connectors in Europe - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in_Europe

   Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...

7. Tow hitch - Wikipedia

   en.wikipedia.org/wiki/Tow_hitch

   The trailer tongue (North America) or coupling (outside North America) slips over a trailer hitch ball attached to a receiver hitch mount or integral with the hitch. A larger, heavy-duty gooseneck ball size: 3 in (76.2 mm) is typically used for towing greater than 10,000 pounds (4.5 t), and this towing capacity falls outside of the scope of SAE ...