Search results
Results from the WOW.Com Content Network
The SI unit for permeability is the square metre (m 2). A practical unit for permeability is the darcy (d), or more commonly the millidarcy (md) (1 d ≈ 10 −12 m 2). The name honors the French Engineer Henry Darcy who first described the flow of water through sand filters for potable water supply. Permeability values for most materials ...
In physics and engineering, permeation (also called imbuing) is the penetration of a permeate (a fluid such as a liquid, gas, or vapor) through a solid.It is directly related to the concentration gradient of the permeate, a material's intrinsic permeability, and the materials' mass diffusivity. [1]
Mass transfer coefficients can be estimated from many different theoretical equations, correlations, and analogies that are functions of material properties, intensive properties and flow regime (laminar or turbulent flow). Selection of the most applicable model is dependent on the materials and the system, or environment, being studied.
Darcy's law is an equation that describes the flow of a fluid through a porous medium and through a Hele-Shaw cell.The law was formulated by Henry Darcy based on results of experiments [1] on the flow of water through beds of sand, forming the basis of hydrogeology, a branch of earth sciences.
The darcy is referenced to a mixture of unit systems. A medium with a permeability of 1 darcy permits a flow of 1 cm 3 /s of a fluid with viscosity 1 cP (1 mPa·s) under a pressure gradient of 1 atm/cm acting across an area of 1 cm 2. Typical values of permeability range as high as 100,000 darcys for gravel, to less than 0.01 microdarcy for ...
The movement of a fluid through porous media is described by the combination of Darcy's law with the principle of conservation of mass in order to express the capillary force or fluid velocity as a function of various other parameters including the effective pore radius, liquid viscosity or permeability. [3]
The most common international unit for the MVTR is g/m 2 /day. In the USA, g/100in 2 /day is also in use, which is 0.064516 (approximately 1/15) of the value of g/m 2 /day units. Typical rates in aluminium foil laminates may be as low as 0.001 g/m 2 /day, whereas the rate in fabrics can measure up to several thousand g/m 2 /day. [citation needed]
Relative permeability, , for phase is then defined from =, as = / where is the permeability of the porous medium in single-phase flow, i.e., the absolute permeability. Relative permeability must be between zero and one.