Search results
Results from the WOW.Com Content Network
Shrouded cable glands going into a flow meter. Split cable gland KVT for routing pre-terminated cables. A cable gland (more often known in the U.S. as a cord grip, cable strain relief, cable connector or cable fitting) is a device designed to attach and secure the end of an electrical cable to the equipment. [1]
Usually, the lines are fixed by clamping them into single cable clamps made of plastic or metal. Another possibility is to use so called cord grips which consist of weaved wire strands that put a grip around the cables. [3] A more cable-friendly alternative is attaching the lines to special strain relief plates using common cable ties. In case ...
Cables usually are secured with special fittings where they enter electrical apparatus; this may be a simple screw clamp for jacketed cables in a dry location, or a polymer-gasketed cable connector that mechanically engages the armour of an armoured cable and provides a water-resistant connection.
Twist-on wire connectors are a type of electrical connector used to fasten two or more low-voltage (or extra-low-voltage) electrical conductors. They are widely used in North America and several European countries in residential, commercial and industrial building power wiring, but have been banned in some other jurisdictions.
In the electrical wiring of buildings, a cable tray system is used to support insulated electrical cables used for power distribution, control, and communication. Cable trays are used as an alternative to open wiring or electrical conduit systems, and are commonly used for cable management in commercial and industrial construction. They are ...
A cable laced wiring harness installed in a component of a Tesla coil Harness of car audio cables.. A cable harness, also known as a wire harness, wiring harness, cable assembly, wiring assembly or wiring loom, is an assembly of electrical cables or wires which transmit signals or electrical power. [1]
Log in to your AOL account to access email, news, weather, and more.
Compared to modern electrical wiring standards, these are the main technical shortcomings of knob-and-tube wiring methods: never included a safety grounding conductor; did not confine switching to the hot conductor (the so-called Carter system prohibited as of 1923 places electrical loads across the common terminals of a three-way switch pair)