Search results
Results from the WOW.Com Content Network
Nd:YAG (neodymium-doped yttrium aluminum garnet; Nd:Y 3 Al 5 O 12) is a crystal that is used as a lasing medium for solid-state lasers. The dopant , neodymium in the +3 oxidation state, Nd(III), typically replaces a small fraction (1%) of the yttrium ions in the host crystal structure of the yttrium aluminum garnet (YAG), since the two ions are ...
Q-switching, sometimes known as giant pulse formation or Q-spoiling, [1] is a technique by which a laser can be made to produce a pulsed output beam. The technique allows the production of light pulses with extremely high peak power, much higher than would be produced by the same laser if it were operating in a continuous wave (constant output) mode.
[citation needed] A Q-switched Nd:YAG laser normally has pulse duration in the order of nanoseconds, peak power on the order of ten to hundreds of MW/cm 2, and a material removal rate of a few micrometers per pulse. A flash lamp pumped Nd:YAG laser normally has a pulse duration on the order of hundreds of microseconds to a millisecond, peak ...
Neodymium-doped yttrium calcium oxoborate Nd:Y Ca 4 O(BO 3) 3 or simply Nd:YCOB ~1.060 μm (~530 nm at second harmonic) laser diode Nd:YCOB is a so-called "self-frequency doubling" or SFD laser material which is both capable of lasing and which has nonlinear characteristics suitable for second harmonic generation. Such materials have the ...
Blue DPSSLs use a nearly identical process, except that the 808 nm light is being converted by an Nd:YAG crystal to 946 nm light (selecting this non-principal spectral line of neodymium in the same Nd-doped crystals), which is then frequency-doubled to 473 nm by a beta barium borate (BBO) crystal or LBO crystal. Because of the lower gain for ...
Laser rods (from left to right): Ruby, Alexandrite, Er:YAG, Nd:YAG The active laser medium (also called a gain medium or lasing medium ) is the source of optical gain within a laser . The gain results from the stimulated emission of photons through electronic or molecular transitions to a lower energy state from a higher energy state previously ...
Also, laser energy can be selectively absorbed by coatings, particularly on metal, so CO 2 or Nd:YAG pulsed lasers can be used to clean surfaces, remove paint or coating, or prepare surfaces for painting without damaging the underlying surface. High power lasers clean a large spot with a single pulse.
A pulse-forming network for an Nd:YAG laser rangefinder The Shiva Star device at Air Force Research Laboratory, USA, which generates pulsed power for high-energy fusion power experiments. Each of the 6 radial arms is a pulse-forming line delivering a pulse of energy to the center, whose capacitors store a total of 10 MJ of energy and can create ...