enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ribbon cable - Wikipedia

   en.wikipedia.org/wiki/Ribbon_cable

   Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).

3. Floppy disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Floppy_disk_drive_interface

   A 'universal' cable would have four drive connectors, two for each size of FDD, although cables which have only two drive connectors are common. The cable is normally a ribbon cable. For IBM-compatible floppy controllers, a twist in the cable reverses the order of conductors 10 through 16 for the second connector.

4. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45) A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35. Connectors on this cable would be designated:

5. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

6. SCSI connector - Wikipedia

   en.wikipedia.org/wiki/SCSI_connector

   This connector has no retaining screws to secure the connectors together, and ribbon cables are both inconveniently wide and somewhat delicate, so this connector style was primarily used for connections inside of a computer or peripheral enclosure (as opposed to connecting two enclosures to each other). Thus it is often called an "internal SCSI ...

7. D-subminiature - Wikipedia

   en.wikipedia.org/wiki/D-subminiature

   These connectors are frequently mounted at a right angle to the PCB, allowing a cable to be plugged into the edge of the PCB assembly. Wire wrap connections are made by wrapping solid wire around a square post with a wire wrap tool. This type of connection is often used in developing prototypes. The wire wrap and IDC connections styles had to ...

8. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Chassis or panel connectors permanently attached to a piece of equipment so users can connect a cable to a stationary device; PCB mount connectors soldered to a printed circuit board, providing a point for cable or wire attachment. [6]: 56 (e.g. pin headers, screw terminals, board-to-board connectors) Splice or butt connectors (primarily ...

9. Pin header - Wikipedia

   en.wikipedia.org/wiki/Pin_header

   1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector.A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1]