enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Floppy disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Floppy_disk_drive_interface

   A 'universal' cable would have four drive connectors, two for each size of FDD, although cables which have only two drive connectors are common. The cable is normally a ribbon cable. For IBM-compatible floppy controllers, a twist in the cable reverses the order of conductors 10 through 16 for the second connector.

3. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   Connectors on this cable would be designated: 1A1W35P1; 1A1W35P2; ASME Y14.44-2008 continues the convention of Plug P and Jack J when assigning references for electrical connectors in assemblies where a J (or jack) is the more fixed and P (or plug) is the less fixed of a connector pair, without regard to the gender of the connector contacts.

4. Ribbon cable - Wikipedia

   en.wikipedia.org/wiki/Ribbon_cable

   Ribbon cable with three connectors. Ribbon cables are usually specified by two numbers: the spacing or pitch of the conductors, and the number of conductors or ways. A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm).

5. Parallel ATA - Wikipedia

   en.wikipedia.org/wiki/Parallel_ATA

   Thus, later cables with the gap filled in are incompatible with earlier connectors, although earlier cables are compatible with later connectors. Round parallel ATA cables (as opposed to ribbon cables) were eventually made available for 'case modders' for cosmetic reasons, as well as claims of improved computer cooling and were easier to handle ...

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Chassis or panel connectors permanently attached to a piece of equipment so users can connect a cable to a stationary device; PCB mount connectors soldered to a printed circuit board, providing a point for cable or wire attachment. [6]: 56 (e.g. pin headers, screw terminals, board-to-board connectors) Splice or butt connectors (primarily ...

7. Via (electronics) - Wikipedia

   en.wikipedia.org/wiki/Via_(electronics)

   A via (Latin, 'path' or 'way') is an electrical connection between two or more metal layers of a printed circuit boards (PCB) or integrated circuit. Essentially a via is a small drilled hole that goes through two or more adjacent layers; the hole is plated with metal (often copper) that forms an electrical connection through the insulating layers.