Search results
Results from the WOW.Com Content Network
where is the heat capacity ratio / of the gas and where is the total (stagnation) upstream pressure. For air with a heat capacity ratio =, then =; other gases have in the range 1.09 (e.g. butane) to 1.67 (monatomic gases), so the critical pressure ratio varies in the range < / <, which means that, depending on the gas, choked flow usually ...
As the pressure is reduced still further, a pressure is reached that result in M = 1 at the throat with subsonic flow throughout the remainder of the nozzle. There is another receiver pressure substantially below that of curve C that also results in isentropic flow throughout the nozzle, represented by curve D; after the throat the flow is ...
The pressure ratios for the design flow rate at the intake and outlet are = / and = /, and the off-design ratios are = / and = /. If the speed of sound is reached in a stage, the group of stages can be analyzed until that stage, which is the last in the group, with the remaining stages forming another group of analysis.
Convergent nozzles are used on many jet engines. If the nozzle pressure ratio is above the critical value (about 1.8:1) a convergent nozzle will choke, resulting in some of the expansion to atmospheric pressure taking place downstream of the throat (i.e., smallest flow area), in the jet wake. Although jet momentum still produces much of the ...
However, the liquid–vapor boundary terminates in an endpoint at some critical temperature T c and critical pressure p c. This is the critical point. The critical point of water occurs at 647.096 K (373.946 °C; 705.103 °F) and 22.064 megapascals (3,200.1 psi; 217.75 atm; 220.64 bar). [3] In the vicinity of the critical point
Figure 3 A supersonic nozzle leading into a constant area duct is depicted. The initial conditions exist at point 1. Point 2 exists at the nozzle throat, where M = 1. Point 3 labels the transition from isentropic to Fanno flow. Points 4 and 5 give the pre- and post-shock wave conditions, and point E is the exit from the duct.
The reduced temperature of a fluid is its actual temperature, divided by its critical temperature: [1] = where the actual temperature and critical temperature are expressed in absolute temperature scales (either Kelvin or Rankine). Both the reduced temperature and the reduced pressure are often used in thermodynamical formulas like the Peng ...
In a nozzle or other constriction, the discharge coefficient (also known as coefficient of discharge or efflux coefficient) is the ratio of the actual discharge to the ideal discharge, [1] i.e., the ratio of the mass flow rate at the discharge end of the nozzle to that of an ideal nozzle which expands an identical working fluid from the same initial conditions to the same exit pressures.