Search results
Results from the WOW.Com Content Network
Both pre and post Doppler methods can be used in the beamspace. Post Doppler methods may also be used on the full antenna element input as well to reduce the data in this dimension only. A popular example is displaced phase center antenna (DPCA), which is a form of data-independent STAP in the beamspace, pre-Doppler. [7]
Here the receiving instrument is on the surface of the Earth. In this technique the interference of the direct and reflected signals is used rather than a Delay Doppler Map or measuring the two signals separately. In the example shown, a GNSS antenna is ~2.5 meters above a planar surface. Both direct (blue) and reflected (red) GNSS signals are ...
Range ambiguity resolution is a technique used with medium pulse-repetition frequency (PRF) radar to obtain range information for distances that exceed the distance between transmit pulses. This signal processing technique is required with pulse-Doppler radar .
Pulse-Doppler signal processing is a radar and CEUS performance enhancement strategy that allows small high-speed objects to be detected in close proximity to large slow moving objects. Detection improvements on the order of 1,000,000:1 are common.
In pulsed radar and sonar signal processing, an ambiguity function is a two-dimensional function of propagation delay and Doppler frequency, (,).It represents the distortion of a returned pulse due to the receiver matched filter [1] (commonly, but not exclusively, used in pulse compression radar) of the return from a moving target.
Calculations for the "slant range" (range between the antenna's phase center and the point on the ground) are done for every azimuth time using coordinate transformations. Azimuth Compression is done after the previous step. Step 5 and 6 are repeated for every pixel, to cover every pixel, and conduct the procedure on every sub-aperture.
Regardless, radars that employ the technique are universally coherent, with a very stable radio frequency, and the pulse packets may also be used to make measurements of the Doppler shift (a velocity-dependent modification of the apparent radio frequency), especially when the PRFs are in the hundreds-of-kilohertz range. Radars exploiting ...
Moving target indication (MTI) is a mode of operation of a radar to discriminate a target against the clutter. [1] It describes a variety of techniques used for finding moving objects, like an aircraft, and filter out unmoving ones, like hills or trees.