Search results
Results from the WOW.Com Content Network
The T-5 has become a popular restomod option for older and classic manual transmission cars, as the overdrive gear can improve fuel economy. [5] In general, retrofitting the T-5 is straightforward for many rear-drive Fords from the 1960s and 1970s, as they are dimensionally compatible. [6]
2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines. Some had the same Mitsubishi manual transmission as the 2.0/2.3 but had different bellhousings. The 2.3, 2.8, and 2.9 also made it into the Ranger, and Bronco II. 4.0L was produced by Ford Cologne Germany (like the unrelated and the all-new metric Taurus/Sable FWD 3.0 V6).
Toyota Motor Corporation's T family is a family of 4/5/6-speed light/medium-duty transmissions found in ... (22 spline) K bell housing with hydraulic clutch. T50 ...
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
A Toploader transmission is a manually shifted gearbox design built in three-speed and four-speed configurations, introduced in 1963 by the Ford Motor Company to replace the BorgWarner T-10. It was used in most Fords and Mercurys from 1964 until 1973, as well as in some foreign models, and is officially designated the 3.03 three speed or Ford ...
The T-56 six speed manual transmission has been used in a wide range of vehicles from General Motors, Dodge, and Ford Motor Company.The transmission was originally designed and built by BorgWarner for the Dodge Viper later being used by GM in 1992 for the generation II and later engines, but from 1998 was built by Tremec, though nothing changed internally.
Historically, a dual-clutch transmission shifts faster than a standard hydraulic automatic transmission with a torque converter or a single-clutch automated manual transmission. This is possible because the DCT can pre-select the next gear and transfer torque from one clutch to the next clutch with the pre-selected next gear, thus reducing ...
Transmissions coupled to four-cylinder engines typically used 21-spline output shafts. The 23-spline manual transmission was universal in the Eagle lines and was generally used with six-cylinder applications. All transfer cases were available with inputs matching either 21- or 23-spline shafts, making transmission swaps possible among various ...