Search results
Results from the WOW.Com Content Network
Compaction of ceramic powders is a forming technique for ceramics in which granular ceramic materials are made cohesive through mechanical densification, either by hot or cold pressing. The resulting green part must later be sintered in a kiln. The compaction process permits an efficient production of parts to close tolerances with low drying ...
Liquid phase sintering is the process of adding an additive to the powder which will melt before the matrix phase. The process of liquid phase sintering has three stages: rearrangement – As the liquid melts capillary action will pull the liquid into pores and also cause grains to rearrange into a more favorable packing arrangement.
Historically, liquid phase sintering was used to process ceramic materials like clay bricks, earthenware, and porcelain.Modern liquid phase sintering was first applied in the 1930s to materials like cemented carbides (e.g. WC-Co) for cutting tools, porous brass (Cu-Sn) for oil-less bearings, and tungsten-heavy alloys (W-Ni-Cu), but now finds applications ranging from superalloys to dental ...
Commercially available equipment for the AM of ceramics mostly relies on layer by layer sintering of powders and is rarely cost-effective. However, the difficulties in machining ceramic articles means that AM techniques can be attractive in situations where production volumes are too low to viably produce molds for slip
Simulation of the outside of the Space Shuttle as it heats up to over 1,500 °C (2,730 °F) during re-entry into the Earth's atmosphere Bearing components made from 100% silicon nitride Si 3 N 4 Ceramic bread knife. Ceramic engineering is the science and technology of creating objects from inorganic, non-metallic materials. This is done either ...
Tape casting (also called doctor blading, knife coating, and shank shifting) [1] is a casting process used in the manufacture of thin ceramic tapes and sheets from ceramic slurry. [2] The ceramic slurry is cast in a thin layer onto a flat surface and then dried and sintered. [3] It's a part of powder metallurgy. [4]: 167
He contributed greatly to methods for processing ceramics, particularly sintering, a method for creating objects out of powders by heating them until they bond. [5] He wrote a series of books on ceramics, culminating in Introduction to Ceramics, a book that became the "founding treatise" for ceramics. [6] Kingery became a full professor in 1962.
Hot pressing is a high-pressure, low-strain-rate powder metallurgy process for forming of a powder or powder compact at a temperature high enough to induce sintering and creep processes. [1] This is achieved by the simultaneous application of heat and pressure. Hot pressing is mainly used to fabricate hard and brittle materials.