Search results
Results from the WOW.Com Content Network
Pulse-width modulation (PWM), also known as pulse-duration modulation (PDM) or pulse-length modulation (PLM), [1] is any method of representing a signal as a rectangular wave with a varying duty cycle (and for some methods also a varying period). PWM is useful for controlling the average power or amplitude delivered by an
The average output voltage is directly proportional to the ON time of chopper. The ratio of ON time to total time is defined as duty cycle. It can be varied between 0 and 1 or between 0 and 100%. Pulse-width modulation (PWM), or pulse-duration modulation (PDM), is a technique used to encode a message into a pulsing signal.
Fig. 2: Top and bottom views of an air-cooled 10kW-Vienna Rectifier (400kHz PWM). The Vienna Rectifier is useful wherever six-switch converters are used for achieving sinusoidal mains current and controlled output voltage, when no energy feedback from the load into the mains is available.
CSI drives can be operated with either PWM or six-step waveform output. Six-step inverter drive topologies (see image): [e] [51] Now largely obsolete, six-step drives can be either VSI or CSI type and are also referred to as variable-voltage inverter drives, pulse-amplitude modulation (PAM) drives, [52] square-wave drives or DC chopper inverter ...
PSIM is an Electronic circuit simulation software package, designed specifically for use in power electronics and motor drive simulations but can be used to simulate any electronic circuit. Developed by Powersim, PSIM uses nodal analysis and the trapezoidal rule integration [2] as the basis of its simulation algorithm. PSIM provides a schematic ...
If the maximum output amplitude, m a, exceeds 3.24, the output waveform of the inverter becomes a square wave. [17] As was true for Pulse-Width Modulation (PWM), both switches in a leg for square wave modulation cannot be turned on at the same time, as this would cause a short across the voltage source.
However, if the IGBTs can be switched fast enough, pulse-width modulation (PWM) can be used to control the voltage magnitude. By varying the durations of the pulses, the effective magnitude of the voltage waveform can be controlled. [16] Since PWM still only produces square waves, harmonic generation is quite significant
PWM rectifier (Pulse-width modulation rectifier) is an AC to DC power converter, that is implemented using forced commutated power electronic semiconductor switches. Conventional PWM converters are used for wind turbines that have a permanent-magnet alternator. [1] Today, insulated gate bipolar transistors are typical switching devices.