enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fixed ladder - Wikipedia

   en.wikipedia.org/wiki/Fixed_ladder

   This means that if there is a 4" (100 mm) gutter projecting from the side of a building, a fixed ladder would have to have standoff brackets that were at least 11" (7" + 4") (280 mm) in length. Cages : Cages are optional for fixed ladders with a floor to floor elevation of less than 20' (6100 mm).

3. Shed - Wikipedia

   en.wikipedia.org/wiki/Shed

   In cold climates, metal sheds with thin walls need to have snow and ice cleared from the roof, because the thin metal may be damaged by a heavy accumulation. Since thin metal sheds weigh much less than wood or PVC plastic sheds, thin metal sheds are more at risk of being damaged by heavy winds. To prevent wind damage, thin metal sheds should be ...

4. Shearing shed - Wikipedia

   en.wikipedia.org/wiki/Shearing_shed

   It is helpful and will save a lot of money if the shed is located near to the electricity supply. At least some yards will be needed to facilitate shedding and count-outs. Regional variants of shearing shed architecture throughout Australia and New Zealand have been identified through different uses of building materials and local styles of design.

5. Extend the Life of Your Yard and Garden Equipment With These ...

   www.aol.com/lifestyle/extend-life-outdoor-tools...

   For premium support please call: 800-290-4726 more ways to reach us

6. Nissen hut - Wikipedia

   en.wikipedia.org/wiki/Nissen_hut

   The cross-section is slightly more than a semi-circle so that the bottom of the hut curves inwards slightly. The exterior is formed from curved corrugated steel sheets 10 feet 6 inches (320 cm) by 2 feet 2 inches (66 cm), laid with a two-corrugation lap at the side and a 6-inch (15 cm) overlap at the ends. Three sheets cover the arc of the hut.

7. List of British Railways shed codes - Wikipedia

   en.wikipedia.org/wiki/List_of_British_Railways...

   Each steam locomotive was allocated to a particular shed and an oval, cast metal plate (usually 4 + 5 ⁄ 8 in × 7 + 1 ⁄ 2 in (120 mm × 190 mm)) [3] with the depot code was bolted to the smokebox on the front of the locomotive. When a locomotive was reallocated to a different shed the plate was taken off and replaced with one from the new shed.