Search results
Results from the WOW.Com Content Network
A tetrahedral chamber is capable of measuring the low frequency limit of the driver without the large footprint required by an anechoic chamber. This compact measurement system for loudspeaker drivers is defined in IEC 60268-21:2018, [1] IEC 60268-22:2020 [2] and AES73id-2019. [3]
"It is difficult and costly to design and manufacture a time- and phase-accurate speaker system. Few of today’s high-end loudspeakers are time- and phase-accurate designs. The audio magazines need to appeal to a broad spectrum of advertisers including many who make speaker systems which are time incoherent.
Loudspeaker acoustics is a subfield of acoustical engineering concerned with the design of loudspeakers. [1] It focuses on the reproduction of sound and the parameters involved in doing so in actual equipment.
The middle speaker is a real loudspeaker. The top and bottom cones are passive radiators. In the same way as a ported loudspeaker, a passive radiator system uses the sound pressure otherwise trapped in the enclosure to excite a resonance that makes it easier for the speaker system to create the deepest pitches (e.g., basslines). The passive ...
The term loudspeaker may refer to individual transducers (also known as drivers) or to complete speaker systems consisting of an enclosure and one or more drivers.. To adequately and accurately reproduce a wide range of frequencies with even coverage, most loudspeaker systems employ more than one driver, particularly for higher sound pressure level (SPL) or maximum accuracy.
Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...
For low order systems however, reconstruction can easily fail entirely when line-of-sight to speakers is blocked, which has led to odd seating arrangements in listening tests. [ 1 ] With-height systems usually provide more unhindered lines-of-sight per direction for a given audience, which might increase their robustness.
Dolby Surround (1982) was the first home audio system to use a rear channel. It and its successor, Dolby Pro Logic (1987), used a single rear surround channel, but often using two speakers connected in anti-phase or a dipole radiator, as shown in the speaker configuration diagram to the right in gray.