Search results
Results from the WOW.Com Content Network
In Microsoft Windows, a command prompt window that uses many of ... Network PCs using a null modem cable or LapLink ... Hostnames are usually resolved to IP addresses
User at modem A issues a dial command: AT-Get the modem's ATtention; D-Dial; T-Touch-Tone; 12125550100-Call this number RING: Modem A begins dialing. Modem B's phone-line rings, and the modem reports the fact. ATA: Computer at modem B issues answer command. CONNECT: CONNECT: The modems connect, and both modems report "connect".
Then, the command ipconfig /renew is executed to request a new IP address. [ 3 ] [ 4 ] Where a computer is connected to a cable or DSL modem, it may have to be plugged directly into the modem network port to bypass the router, before using ipconfig /release and turning off the power for a period of time, to ensure that the old IP address is ...
Modems always start out in command mode when powered up. Here are the ways a modem can switch to data mode: After a successful dial-out connection in response to an "ATD" dial command in which the modem reaches another modem. After answering the phone with the "ATA" answer command, if another modem is on the other end.
Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything is securely connected to the wall and device. 3. Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure ...
Cable modem termination system. A cable modem termination system (CMTS, also called a CMTS Edge Router) [1] is a piece of equipment, typically located in a cable company's headend or hubsite, which is used to provide data services, such as cable Internet or Voice over IP, to cable subscribers.
Altice USA (also known as Optimum); AT&T Internet; Charter Communications (also known as Spectrum); Comcast High Speed Internet (also known as Xfinity); Consolidated Communications (including FairPoint Communications)
Local Address – The IP address of the local computer and the port number being used. The name of the local computer that corresponds to the IP address and the name of the port is shown unless the -n parameter is specified. An asterisk (*) is shown for the host if the server is listening on all interfaces.