Search results
Results from the WOW.Com Content Network
PVC closet flange with steel flange, before installation. In plumbing, a closet flange (also known as a toilet flange) is a pipe fitting (specifically, a type of flange) that both mounts a toilet to the floor and connects the closet bend to a drain pipe. The name comes from the term "water closet", the traditional name for a toilet. Closet ...
The vent pipe should have an internal diameter of at least 110 mm (4¼") and reach more than 300 mm (12") above the highest point of the toilet superstructure. Typically, the pit is at least 3 metres (10') deep and 1 to 1.5 metres (3' to 5') in diameter, depending on the number of users. Deep pits can last up to 20 or more years. [30]
A skyscraper called Torre Eurosky (Eurosky Tower), built in 2012 in EUR neighbourhood (outside the ban area) exceeds this limit being 155 m (509 ft) high. There is however a height restriction for new onshore wind turbines in the European Union, which set their total height to 200 m (660 ft). [12] [citation needed]
For example, a "W10x22" beam is approximately 10 in (254 mm) in depth with a nominal height of the I-beam from the outer face of one flange to the outer face of the other flange, and weighs 22 lb/ft (33 kg/m). Wide flange section beams often vary from their nominal depth. In the case of the W14 series, they may be as deep as 22.84 in (580 mm).
A low-flush toilet (or low-flow toilet or high-efficiency toilet) is a flush toilet that uses significantly less water than traditional high-flow toilets. Before the early 1990s in the United States, standard flush toilets typically required at least 3.5 gallons (13.2 litres) per flush and they used float valves that often leaked, increasing their total water use.
A flushometer is usually installed in a commercial setting with the exception of some older apartments in large cities, [2] as it provides a high-pressure and better-performing wash and flush than a normal gravity toilet.
According to ADA the height of toilet bowl shall be 17 inches (430 mm) at a minimum when measured from the floor to the top of the toilet seat. Flush controls shall be hand operated or automatic mounted on the wide side of the toilet area and easily reached and operated.
ISO 1004 Information processing – Magnetic ink character recognition – Print specifications ISO 1004-1:2013 Part 1: Print specifications for E-13B; ISO 1004-2:2013 Part 2: Print specifications for CMC7; ISO 1005 Railway rolling stock material ISO 1005-1:1994 Part 1: Rough-rolled tyres for tractive and trailing stock — Technical delivery ...