Search results
Results from the WOW.Com Content Network
Diode circuit implementing AND in active-high logic. Note: in analog implementation exact output currents will be different from +5V supply. This circuit mirrors the previous gate: the diodes are reversed so that each input connects to the cathode of a diode and all anodes are connected together to the output, which has a pull-up resistor.
A diode's high resistance to current flowing in the reverse direction suddenly drops to a low resistance when the reverse voltage across the diode reaches a value called the breakdown voltage. This effect is used to regulate voltage (Zener diodes) or to protect circuits from high voltage surges (avalanche diodes).
A diode-OR circuit is used in electronics to isolate two or more voltage sources. There are two typical implementations: There are two typical implementations: When a DC supply voltage needs to be generated from one of a number of different sources, for example when terminating a parallel SCSI bus, a very simple circuit like this can be used:
In low voltage converters (around 10 volts and less), the voltage drop of a diode (typically around 0.7 to 1 volt for a silicon diode at its rated current) has an adverse effect on efficiency. One classic solution replaces standard silicon diodes with Schottky diodes, which exhibit very low voltage drops (as low as 0.3 volts). However, even ...
The real diode now can be replaced with the combined ideal diode, voltage source and resistor and the circuit then is modelled using just linear elements. If the sloped-line segment is tangent to the real diode curve at the Q-point, this approximate circuit has the same small-signal circuit at the Q-point as the real diode.
If the semiconductor is translucent, the junction becomes the source of light, thus becoming a light-emitting diode. I-V diagram for a diode. An LED begins to emit light when more than 2 or 3 volts is applied in the forward direction.
An LED strip, tape, or ribbon light is a flexible circuit board populated by surface-mount light-emitting diodes (SMD LEDs) and other components that usually comes with an adhesive backing. Traditionally, strip lights had been used solely in accent lighting, backlighting, task lighting, and decorative lighting applications, such as cove lighting .
A diode-connected transistor is a method of creating a two-terminal rectifying device (a diode) out of a three-terminal transistor. A characteristic of diode-connected transistors is that they are always in the saturation region for metal–oxide–semiconductor field-effect transistors (MOSFETs) and junction-gate field-effect transistors ...