Search results
Results from the WOW.Com Content Network
This corresponds to a well-stacked woodpile, 4 feet deep by 4 feet high by 8 feet wide (122 cm × 122 cm × 244 cm), or any other arrangement of linear measurements that yields the same volume. A more unusual measurement for firewood is the "rick" or face cord.
The quarter of a yard (9 inches) was known as the "quarter" without further qualification, while the sixteenth of a yard (2.25 inches) was called a nail. [62] The eighth of a yard (4.5 inches) was sometimes called a finger, [63] but was more commonly referred to simply as an eighth of a yard, while the half-yard (18 inches) was called "half a ...
During the Anglo-Saxon period, the North German foot of 13.2 inches (335 millimetres) was the nominal basis for other units of linear measurement. The foot was divided into 4 palms or 12 thumbs. A cubit was 2 feet, an elne 4 feet. The rod was 15 Anglo-Saxon feet, the furlong 10 rods.
Under the Harappan linear measures, Indus cities during the Bronze Age used a foot of 13.2 inches (335 mm) and a cubit of 20.8 inches (528 mm). [11] The Egyptian equivalent of the foot—a measure of four palms or 16 digits—was known as the djeser and has been reconstructed as about 30 cm (11.8 in).
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
The map commission wanted to adopt decimal measures; and Switzerland did not have an already existing map which, like the Cassini map, used a scale close to 1:86 400, i.e. 1 line (1 ⁄ 12 of a French inch) to 100 toises (i.e. 600 French feet). The metre was adopted as a linear measure, and the entire map was divided into twenty-five sheets ...
SFM is a combination of diameter and the velocity of the material measured in feet-per-minute as the spindle of a milling machine or lathe. 1 SFM equals 0.00508 surface meter per second (meter per second, or m/s, is the SI unit of speed). The faster the spindle turns, and/or the larger the diameter, the higher the SFM.
Unlike a linear scale where each unit of distance corresponds to the same increment, on a logarithmic scale each unit of length is a multiple of some base value raised to a power, and corresponds to the multiplication of the previous value in the scale by the base value. In common use, logarithmic scales are in base 10 (unless otherwise specified).