Search results
Results from the WOW.Com Content Network
The USB 3.1 specification takes over the existing USB 3.0's SuperSpeed USB transfer rate, now referred to as USB 3.1 Gen 1, and introduces a faster transfer rate called SuperSpeed USB 10 Gbps, corresponding to operation mode USB 3.1 Gen 2, [62] putting it on par with a single first-generation Thunderbolt channel.
The USB 3.0 specification defined a new architecture and protocol named SuperSpeed (aka SuperSpeed USB, marketed as SS), which included a new lane for a new signal coding scheme (8b/10b symbols, 5 Gbit/s; later also known as Gen 1) providing full-duplex data transfers that physically required five additional wires and pins, while preserving the ...
The written USB 3.0 specification was released by Intel and its partners in August 2008. The first USB 3.0 controller chips were sampled by NEC in May 2009, [4] and the first products using the USB 3.0 specification arrived in January 2010. [5] USB 3.0 connectors are generally backward compatible, but include new wiring and full-duplex operation.
USB ports and connectors are often color-coded to distinguish their different functions and USB versions. These colors are not part of the USB specification and can vary between manufacturers; for example, the USB 3.0 specification mandates appropriate color-coding while it only recommends blue inserts for Standard-A USB 3.0 connectors and plugs.
The USB 3.x family has had the same technical notation retroactively added in the USB 3.1 and USB 3.2 specification versions. Though this shows common principles and the same generations refer to the same nominal speeds, "Gen A" does not have the same exact meaning in both USB 3.x and USB4 specifications.
The xHCI reduces the need for periodic device polling by allowing a USB 3.0 or later device to notify the host controller when it has data available to read, and moves the management of polling USB 2.0 and 1.1 devices that use interrupt transactions from the CPU-driven USB driver to the USB host controller.
The Linux kernel has supported USB mass-storage devices since version 2.3.47 [3] (2001, backported to kernel 2.2.18 [4]).This support includes quirks and silicon/firmware bug workarounds as well as additional functionality for devices and controllers (vendor-enabled functions such as ATA command pass-through for ATA-USB bridges, used for S.M.A.R.T. or temperature monitoring, controlling the ...
Thus, not all USB 2.0 hubs operate at high speed. USB 3.0 is the third major version of the Universal Serial Bus (USB) standard for interfacing computers and electronic devices. Among other improvements, USB 3.0 adds the new transfer rate referred to as SuperSpeed USB (SS) that can transfer data at up to 5 Gbit/s (625 MB/s), which is about 10 ...