enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Motorcycle tyre - Wikipedia

   en.wikipedia.org/wiki/Motorcycle_tyre

   They were used on the first production motorcycle, the 1894–1897 Hildebrand & Wolfmüller, and have been on nearly all production and special motorcycles ever since. [5] [6] During this period tyre sizes were usually 22 to 28 inches (560 to 710 mm) diameter and 1 + 1 ⁄ 2 to 2 in (38 to 51 mm) wide. [6] A: Typical outer casing of a tyre.

3. TT100 (motorcycle tyre) - Wikipedia

   en.wikipedia.org/wiki/TT100_(motorcycle_tyre)

   Originally introduced in early 1968 as the Roadmaster K81 rear tyre [6] by Dunlop Rubber Co. Ltd, [7] the tyre was renamed "TT100" because it was the first production tyre to reach a lap speed of 100 mph over the Isle of Man TT race course when Malcolm Uphill rode his works Thruxton Bonneville to victory in 1969 with a fastest lap of 100.37 mph during the 750 cc class production race.

4. Tire code - Wikipedia

   en.wikipedia.org/wiki/Tire_code

   Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [24] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.

5. Overdrive (mechanics) - Wikipedia

   en.wikipedia.org/wiki/Overdrive_(mechanics)

   [a] As the tire RPM at maximum speed is not the same as the engine RPM at that power, a transmission is used with a gear ratio to convert one to the other. [ b ] At even slightly lower speeds than maximum, the total drag on the vehicle is considerably less, and the engine needs to deliver this greatly reduced amount of power.

6. Gear inches - Wikipedia

   en.wikipedia.org/wiki/Gear_inches

   For bicycles with 700c wheels, some cyclists quote gear inches based on a nominal wheel diameter of 27 inches, corresponding to the old British tire size of 27 x 1 + 1 ⁄ 4" (ETRTO 630). Strictly speaking, the rolling diameter of a 700c wheel may be significantly higher or lower than 27", depending on the tire size, e.g. nearly 27.5" for a ...

7. Bicycle and motorcycle dynamics - Wikipedia

   en.wikipedia.org/wiki/Bicycle_and_motorcycle...

   For example, a motorcycle with a 12 inch wide rear tire will have t = 6 inches. If the combined bike and rider center of mass is at a height of 26 inches, then a 25° lean must be increased by 7.28°: a nearly 30% increase. If the tires are only 6 inches wide, then the lean angle increase is only 3.16°, just under half.