enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Test fixture - Wikipedia

   en.wikipedia.org/wiki/Test_fixture

   Test fixtures can be set up three different ways: in-line, delegate, and implicit. In-line setup creates the test fixture in the same method as the rest of the test. While in-line setup is the simplest test fixture to create, it leads to duplication when multiple tests require the same initial data.

3. In-circuit testing - Wikipedia

   en.wikipedia.org/wiki/In-circuit_testing

   A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.

4. Cable tester - Wikipedia

   en.wikipedia.org/wiki/Cable_tester

   A cable tester is an electronic device used to verify the electrical connections in a signal cable or other wired assembly. Basic cable testers are continuity testers that verify the existence of a conductive path between ends of the cable, and verify the correct wiring of connectors on the cable. More advanced cable testers can measure the ...

5. Continuity tester - Wikipedia

   en.wikipedia.org/wiki/Continuity_tester

   Entry-level cable testers are essentially continuity testers. A continuity tester is an item of electrical test equipment used to determine if an electrical path can be established between two points; [1] that is if an electrical circuit can be made. The circuit under test is completely de-energized prior to connecting the apparatus. [1]

6. Closed-circuit television - Wikipedia

   en.wikipedia.org/wiki/Closed-circuit_television

   In Canada, Project SCRAM is a policing effort by the Canadian policing service Halton Regional Police Service to register and help consumers understand privacy and safety issues related to the installations of home security systems. The project service has not been extended to commercial businesses.

7. VLF cable testing - Wikipedia

   en.wikipedia.org/wiki/VLF_cable_testing

   The VLF test can be used in a number of ways: Apply VLF to cables in a simple withstand approach to detect potential failures in the cable insulation during a planned outage. The tested cable must withstand an AC voltage for a specified testing time without flashover. This method yields a "pass/fail" statement.