Search results
Results from the WOW.Com Content Network
The Nuclear Regulatory Commission (NRC) now mandates the use of data diodes and many other sectors, in addition to electrical and nuclear, also use data diodes effectively. [1] In Europe, regulators and operators of several safety-critical systems started recommending and implementing regulations on the use of unidirectional gateways. [6]
The real diode now can be replaced with the combined ideal diode, voltage source and resistor and the circuit then is modelled using just linear elements. If the sloped-line segment is tangent to the real diode curve at the Q-point, this approximate circuit has the same small-signal circuit at the Q-point as the real diode.
Simulation-based methods for time-based network analysis solve a circuit that is posed as an initial value problem (IVP). That is, the values of the components with memories (for example, the voltages on capacitors and currents through inductors) are given at an initial point of time t 0 , and the analysis is done for the time t 0 ≤ t ≤ t f ...
Large-signal modeling is a common analysis method used in electronic engineering to describe nonlinear devices in terms of the underlying nonlinear equations. In circuits containing nonlinear elements such as transistors, diodes, and vacuum tubes, under "large signal conditions", AC signals have high enough magnitude that nonlinear effects must be considered.
A worst-case circuit analysis should be performed on all circuitry that is safety and financially critical. Worst-case circuit analysis is an analysis technique which, by accounting for component variability, determines the circuit performance under a worst-case scenario (under extreme environmental or operating conditions).
Diode circuit implementing AND in active-high logic. Note: in analog implementation exact output currents will be different from +5V supply. This circuit mirrors the previous gate: the diodes are reversed so that each input connects to the cathode of a diode and all anodes are connected together to the output, which has a pull-up resistor.
Non-stick coatings, reduction of contact area, and increased awareness mitigate the problem in contemporary systems. [9] Particles migrating in the system and blocking their movements. Conductive particles may short out circuits like electrostatic actuators. Wear damages the surfaces and releases debris that can be a source of particle ...
Simulation software allows for the modeling of circuit operation and is an invaluable analysis tool. Due to its highly accurate modeling capability, many colleges and universities use this type of software for the teaching of electronics technician and electronics engineering programs.