Search results
Results from the WOW.Com Content Network
A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency (RF) signal into a higher-power signal. [1] Typically, RF power amplifiers are used in the final stage of a radio transmitter , their output driving the antenna .
Envelope tracking waveform. Envelope tracking (ET) describes an approach to radio frequency (RF) amplifier design in which the power supply voltage applied to the RF power amplifier is continuously adjusted to ensure that the amplifier is operating at peak efficiency for power required at each instant of transmission.
Radio-frequency (RF) engineering is a subset of electrical engineering involving the application of transmission line, waveguide, antenna, radar, and electromagnetic field principles to the design and application of devices that produce or use signals within the radio band, the frequency range of about 20 kHz up to 300 GHz.
A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...
Keeping multiple tuned circuits aligned while tuning over a wide frequency range is difficult. In the early TRF sets the operator had to perform that task, as described above. A superheterodyne receiver only needs to track the RF and LO stages; the onerous selectivity requirements are confined to the IF amplifier which is fixed-tuned.
Design of a radio receiver must consider several fundamental criteria to produce a practical result. The main criteria are gain, selectivity, sensitivity, and stability.. The receiver must contain a detector to recover the information initially impressed on the radio carrier signal, a process called modulati
A linear amplifier is an electronic circuit whose output is proportional to its input, but capable of delivering more power into a load. The term usually refers to a type of radio-frequency (RF) power amplifier , some of which have output power measured in kilowatts , and are used in amateur radio .
A regenerative circuit is an amplifier circuit that employs positive feedback (also known as regeneration or reaction). [ 1 ] [ 2 ] Some of the output of the amplifying device is applied back to its input to add to the input signal, increasing the amplification. [ 3 ]