Search results
Results from the WOW.Com Content Network
The sense pin is used to relay the rotation speed of the fan and the control pin is an open-drain or open-collector output, which requires a pull-up to 5 V or 3.3 V in the fan. Unlike linear voltage regulation, where the fan voltage is proportional to the speed, the fan is driven with a constant supply voltage; the speed control is performed by ...
This is a special variant of the Molex KK connector with four pins but with the locking/polarisation features of a three-pin connector. The additional pin is used for a pulse-width modulation (PWM) signal to provide variable speed control. [26] These can be plugged into 3-pin headers, but will lose their fan speed control.
It is possible to use Socket 7 processors in a Socket 5. An adapter is required, or if one is careful, a socket 7 can be pulled off its pins and put onto a socket 5 board, allowing the use of socket 7 processors. Socket 8: 1995 Intel Pentium Pro: PGA: 387 ? 60–66 MHz Slot 1: 1997 Intel Pentium II Intel Pentium III: Desktop Slot: 242 ? 66 ...
Pins and sockets can be arranged in any combination in a single housing, and each housing can be either male or female. There are three typical pin sizes: 1.57 mm (0.062 in), 2.13 mm (0.084 in), and 2.36 mm (0.093 in). The 1.57 mm pin can carry 5 A of current, while the 2.36 mm can carry 8.5 A.
Heat-sink types: pin, straight, and flared fin. A pin fin heat sink is a heat sink that has pins that extend from its base. The pins can be cylindrical, elliptical, or square. A second type of heat sink fin arrangement is the straight fin. A variation on the straight fin heat sink is a cross-cut heat sink.
The yellow P+N+E, 4h (120°) plug is a single phase connector that is in widespread use on the British Isles for 110 V building site and fairground applications. A popular model of this socket type is marketed under the brand name MK Commando [12] which leads some users to refer to all IEC 60309 sockets by the generic trademark Commando sockets.
View of the socket LGA 1155 on an Intel Core i7 Sandy Bridge 2600K model CPU Celeron G530 "Sandy Bridge" installed on a Socket 1155. LGA 1155, also called Socket H2, is a zero insertion force flip-chip land grid array (LGA) CPU socket designed by Intel for their CPUs based on the Sandy Bridge (second generation core) and Ivy Bridge (third generation) microarchitectures.
Socket 370, also known as PGA370, is a CPU socket first used by Intel for Pentium III and Celeron processors to first complement and later replace the older Slot 1 CPU interface on personal computers. The "370" refers to the number of pin holes in the socket for CPU pins. Socket 370 was replaced by Socket 423 in 2000.