Search results
Results from the WOW.Com Content Network
Rising damp is the effect of water rising from the ground into property. [3] The damp proof course may be horizontal or vertical. [4] A DPC layer is usually laid below all masonry walls, regardless if the wall is a load bearing wall or a partition wall. A damp-proof membrane (DPM) is a membrane material
The purpose of a Vertical Damp Proof Barrier is to prevent the ingress of damp and water into subterranean structures such as basements, cellars, tunnels and earth shielded buildings. (Also known as Earth sheltered buildings ).
Damp proofing: This is waterproofing used where the water table is lower than the structure and there is good free-draining fill. The membrane deals with the shedding of water and the ingress of water vapor only, with no hydrostatic pressure. Generally, this incorporates a damp proof membrane (DPM) to the walls with a polythene DPM under the ...
Elastomeric coatings can provide a vapor barrier and water proofing with permeability ratings of .016 perm rating with 10 mils/min. of coating and can be applied on interior or exterior surfaces. Aluminum foil , 0.05 US perm (2.9 SI perm).
Damp-proofing rods are available with BBA approval. The rods are placed into holes drilled in the mortar course and the active ingredients diffuse along the mortar line before curing to form a damp-proof course. [53] Damp-proofing rods are usually supplied in 180mm (7") lengths suitable for inserting into a 9-inch thick wall.
Once excavated, the walls are then power washed and allowed to dry. The dry walls are sealed with a waterproofing membrane, [3] and new drainage tiles (weeping tiles) are placed at the side of the footing. A French drain, PVC pipe, or other drainage system is installed and water is led further from the basement.
Replacing the roofing felt on a Scout hall in Wales. Bituminous waterproofing systems are designed to protect residential and commercial buildings.Bitumen (asphalt or coal-tar pitch) is a material made up of organic liquids that are highly sticky, viscous, and waterproof. [1]
The finished roof's thickness is usually between 30 and 120 mils (thousandths of an inch; 0.75 mm to 1.50 mm). The most commonly used cured elastomer membranes are ethylene propylene diene monomer (commonly EPDM) and neoprene, although all thermoset products combined fail to account for more than 10% of all commercial roofing. This is in part ...