Search results
Results from the WOW.Com Content Network
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
The Fournier scale: two inches in total, divided into four half-inches, the medium intervals are one line (1 ⁄ 12 inch), and the smallest intervals are 1 ⁄ 36 inch; no intervals for the point is given, though. Fournier printed a reference scale of 144 points over two inches; however, it was too rough to accurately measure a single point. [11]
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
The pica is a typographic unit of measure corresponding to approximately 1 ⁄ 6 of an inch, or from 1 ⁄ 68 to 1 ⁄ 73 of a foot. One pica is further divided into 12 points. In printing, three pica measures are used: The French pica of 12 Didot points (also called cicero) generally is: 12 × 0.376 = 4.512 mm (0.1776 in).
Tape measure with 16 and 19.2 inch marks Most tapes sold in the United States are inches - and feet -based. Some tapes have additional marks in the shape of small black diamonds, appearing every 19.2 inches (488 mm), used to mark out equal spacing for joists (five joists or trusses per US standard 8-foot (2,438 mm) length of building material).
10.16 cm = 1.016 dm – 1 hand used in measuring height of horses (4 inches) 12 cm = 1.2 dm – diameter of a compact disc (CD) (= 120 mm) 15 cm = 1.5 dm – length of a Bic pen with cap on; 22 cm = 2.2 dm – diameter of a typical association football (soccer ball) 30 cm = 3 dm – typical school-use ruler length (= 300 mm)
The traditional typographic units are based either on non-metric units, or on odd multiples (such as 35 ⁄ 83) of a metric unit.There are no specifically metric units for this particular purpose, although there is a DIN standard sometimes used in German publishing, which measures type sizes in multiples of 0.25 mm, and proponents of the metrication of typography generally recommend the use of ...
Inside small jaws: used to measure the internal diameter of an object (like a hollow cylinder or pipe). Depth probe, or depth rod: used to measure depths of an object (like a small beaker) or a hole. Main scale (metric): marked every millimeter and helps to measure length correct up to 1 mm. Main scale (imperial): marked in inches and fractions.