enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Voltage converter - Wikipedia

   en.wikipedia.org/wiki/Voltage_converter

   A simple voltage dropper can be used to reduce the voltage for low-power devices; if more than 12V is required, or for high-powered devices, a switched-mode power supply is used. The output will usually be DC in the range 1.5–24 V. Power supplies that output either 100–120 V AC or 210–240 V AC are available; they are called inverters ...

3. Power inverter - Wikipedia

   en.wikipedia.org/wiki/Power_inverter

   A power inverter, inverter, or invertor is a power electronic device or circuitry that changes direct current (DC) to alternating current (AC). [1] The resulting AC frequency obtained depends on the particular device employed. Inverters do the opposite of rectifiers which were originally large electromechanical devices converting AC to DC. [2]

4. File:Three-Phase Voltage Source Inverter Circuit Schematic ...

   en.wikipedia.org/wiki/File:Three-Phase_Voltage...

   Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate

5. Soft-switching three-level inverter - Wikipedia

   en.wikipedia.org/wiki/Soft-switching_three-level...

   A soft-switching three-level inverter (S3L inverter) is a high-efficiency power electronic inverter intended, in particular, for use with three-phase drives, as a grid-tie inverter for photovoltaic installations or wind turbines and in power supplies. [1] The topology was developed in 2009 at HTWG Konstanz (Constance University of Applied ...

6. Buck converter - Wikipedia

   en.wikipedia.org/wiki/Buck_converter

   Fig. 8: Simplified schematic of a synchronous converter, in which D is replaced by a second switch, S 2. A synchronous buck converter is a modified version of the basic buck converter circuit topology in which the diode, D, is replaced by a second switch, S 2. This modification is a tradeoff between increased cost and improved efficiency.

7. Push–pull converter - Wikipedia

   en.wikipedia.org/wiki/Push–pull_converter

   Push-pull converter (+12V → ±18V; 50W) as potted module. ① transformer; ② and ③ electrolytic capacitors vertical and horizontal mounted; ④ discrete circuit board in through-hole technology. A push–pull converter is a type of DC-to-DC converter, a switching converter that uses a transformer to change the voltage of a DC power supply.

8. Electric power conversion - Wikipedia

   en.wikipedia.org/wiki/Electric_power_conversion

   Certain specialized circuits can also be considered power converters, such as the flyback transformer subsystem powering a CRT, generating high voltage at approximately 15 kHz. Consumer electronics usually include an AC adapter (a type of power supply) to convert mains-voltage AC current to low-voltage DC suitable for consumption by microchips.

9. Single-ended primary-inductor converter - Wikipedia

   en.wikipedia.org/wiki/Single-ended_primary...

   Figure 1: Schematic of SEPIC. The single-ended primary-inductor converter (SEPIC) is a type of DC/DC converter that allows the electrical potential at its output to be greater than, less than, or equal to that at its input. The output of the SEPIC is controlled by the duty cycle of the electronic switch (S1).