Search results
Results from the WOW.Com Content Network
0.02831685 m 3. The cubic foot (symbol ft3 or cu ft) [1] is an imperial and US customary (non-metric) unit of volume, used in the United States and the United Kingdom. It is defined as the volume of a cube with sides of one foot (0.3048 m) in length. Its volume is 28.3168 L (about 1⁄35 of a cubic metre).
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0 ...
Unit of volume. A unit of volume is a unit of measurement for measuring volume or capacity, the extent of an object or space in three dimensions. Units of capacity may be used to specify the volume of fluids or bulk goods, for example water, rice, sugar, grain or flour.
US dry barrel: 7,056 cubic inches (115.6 litres; 3.3 US bushels) . Defined as length of stave 28 + 1 ⁄ 2 in (72 cm), diameter of head 17 + 1 ⁄ 8 in (43 cm), distance between heads 26 in (66 cm), circumference of bulge 64 in (160 cm) outside measurement; representing as nearly as possible 7,056 cubic inches; and the thickness of staves not greater than 4 ⁄ 10 in (10 mm) [2] (diameter ≈ ...
For petroleum gases, the standard cubic foot (scf) is defined as one cubic foot of gas at 60 °F (288.7 K; 15.56 °C) and at normal sea level air pressure. The pressure definition differs between sources, but are all close to normal sea level air pressure. A pressure of 14.696 pounds per square inch (1.00000 atm; 101.325 kPa). [2]
Municipal volumetric water measurements, including city water flow and cost per unit on a residential water bill, can either be measured in gallons, cubic feet, or cubic meters, with gallons being the most commonly used. Water bottles for personal use can have their capacity measured in fluid ounces or liters. For ounces, the measurements are ...
An input unit can be converted to any number of output units—the outputs are specified as a "combination" by separating unit codes with a space (" ") or a plus (" + "). Using a space as a separator does not work if any of the unit codes contains a space. For example, each of the following converts 1.2 km 2 to acres, square yards, and hectares.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...