Search results
Results from the WOW.Com Content Network
Four-stroke cycle used in gasoline/petrol engines: intake (1), compression (2), power (3), and exhaust (4). The right blue side is the intake port and the left brown side is the exhaust port. The cylinder wall is a thin sleeve surrounding the piston head which creates a space for the combustion of fuel and the genesis of mechanical energy.
Camshaft. In four-stroke cycle engines and some two-stroke cycle engines, the valve timing is controlled by the camshaft. It can be varied by modifying the camshaft, or it can be varied during engine operation by variable valve timing. It is also affected by the adjustment of the valve mechanism, and particularly by the tappet clearance.
Changing the engine to a V6 often requires changing the bellhousing (Mitsubishi) but the Mazda trans had an integral bell. 2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines. Some had the same Mitsubishi manual transmission as the 2.0/2.3 but had different bellhousings. The 2.3, 2.8, and 2.9 also made it into the Ranger, and ...
The engine has a total displacement of 1,998 cc (122 cu in) from a square 86 mm × 86 mm (3.4 in × 3.4 in) bore x stroke with a compression ratio of 16.3:1 and uses five main bearings. The EE20 shares a bore pitch dimension and assembly line with the EZ30 at the Ooizumi Factory; compared to the contemporaneous gasoline EJ20, which has a ...
Chevrolet V8 pattern. This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s. Chevrolet small-block V8s. GM Vortec 4300 90° V6. GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in³ (1980-1983 ...
The Subaru FB engine is the third and current generation of gasoline boxer-4 engine used in Subaru automobiles, and was announced on 23 September 2010. [1] It follows the previous generation EJ-series engine which was introduced in 1989 and the first generation EA-series which was introduced in 1966. By increasing piston stroke and decreasing ...
The first person to build a working four-stroke engine, a stationary engine using a coal gas-air mixture for fuel (a gas engine), was German engineer Nicolaus Otto. [4] This is why the four-stroke principle today is commonly known as the Otto cycle and four-stroke engines using spark plugs often are called Otto engines.
An indicator diagram is a chart used to measure the thermal, or cylinder, performance of reciprocating steam and internal combustion engines and compressors. [ 1] An indicator chart records the pressure in the cylinder versus the volume swept by the piston, throughout the two or four strokes of the piston which constitute the engine, or ...