enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   Chucking reamers, or machine reamers, are the most common type of reamer used in lathes, drill presses, and screw machines that provide a smooth finish to the hole. They come in a variety of flutes and cuts (e.g. right hand cut, left hand spiral, straight flute) as well as different shank types.

3. Automatic tool changer - Wikipedia

   en.wikipedia.org/wiki/Automatic_Tool_Changer

   But if even more tools are required, then an ATC is needed. The tools are stored in a magazine. This allows the machine to work with a large number of tools without operator intervention. The main parts of an automatic tool changer are the base, the gripper arm, the tool holder, the support arm, and the tool magazines. [2]

4. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.

5. Machine tool - Wikipedia

   en.wikipedia.org/wiki/Machine_tool

   A biography of a machine tool builder that also contains some general history of the industry. Rolt, L. T. C. (1965), A Short History of Machine Tools, Cambridge, Massachusetts, USA: MIT Press, OCLC 250074. Co-edition published as Rolt, L. T. C. (1965), Tools for the Job: a Short History of Machine Tools, London: B. T. Batsford, LCCN 65080822.

6. Shaper - Wikipedia

   en.wikipedia.org/wiki/Shaper

   A single-point cutting tool is rigidly held in the tool holder, which is mounted on the ram. The work piece is rigidly held in a vise or clamped directly on the table. The table may be supported at the outer end. The ram reciprocates and the cutting tool, held in the tool holder, moves forwards and backwards over the work piece.

7. Way (machine tool element) - Wikipedia

   en.wikipedia.org/wiki/Way_(machine_tool_element)

   The geometry of the way can vary depending on the situation. The most common types are flat, vee, and dovetail ways. Flat ways are used when there is little requirement for the slide to be constrained perpendicular to the axis of movement, or the constraint is being provided by another component or otherwise not needed, such as on the carriage of a lathe.