Search results
Results from the WOW.Com Content Network
Valve seats are often formed by first press-fitting an approximately cylindrical piece of a hardened metal alloy, such as Stellite, into a cast depression in a cylinder head above each eventual valve stem position, [1] and then machining a conical-section surface into the valve seat that will mate with a corresponding conical section of the ...
The upper part of the valve stem, within the rocker box, is lubricated by oil. If this oil travels unchecked along the valve stem, engine HC emissions will become excessive. To control this, an elastomeric seal is fitted over the top of the valve guide. These may wear or stiffen with age, so are usually replaced whenever valves are removed for ...
Multi-seat valve with pneumatic actuator. Multi-seat valves, or multi-port valves, are used to shut off or control complex liquid flows in sterile areas in the beverage and food industry as well as in the fine chemical and pharmaceutical industry. Multi-seat valves often replace combinations of several single-seated valves in aseptic processing.
Medical gas cylinders in the UK and some other countries have a fusible plug of Wood's metal in the valve block between the valve seat and the cylinder. [ citation needed ] This plug melts at a comparatively low temperature (70 °C) and allows the contents of the cylinder to escape to the surroundings before the cylinder is significantly ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Discover the best free online games at AOL.com - Play board, card, casino, puzzle and many more online games while chatting with others in real-time.
A tappet or valve lifter is a valve train component which converts rotational motion into linear motion in activating a valve. It is most commonly found in internal combustion engines , where it converts the rotational motion of the camshaft into linear motion of intake and exhaust valves, either directly or indirectly.
Pneumatic valves are operated by a pilot medium under pressure, usually compressed air but also oil or water. The valve is equipped with a pneumatic actuator supplied by a three-way solenoid valve. The pressure of the pilot medium enters the actuator cylinder and acts on the piston, which allows the seal to open or to close through the stem.