Search results
Results from the WOW.Com Content Network
Diastrophism is the process of deformation of the Earth's crust which involves folding and faulting. Diastrophism can be considered part of geotectonics. The word is derived from the Greek διαστροϕή diastrophḗ 'distortion, dislocation'. [1]
Typically, folding is thought to occur by simple buckling of a planar surface and its confining volume. The volume change is accommodated by layer parallel shortening the volume, which grows in thickness. Folding under this mechanism is typical of a similar fold style, as thinned limbs are shortened horizontally and thickened hinges do so ...
Drag folding is a zone of folding close to a fault that likely arises from frictional resistance to movement on the fault. [13] The direction and magnitude of heave and throw can be measured only by finding common intersection points on either side of the fault (called a piercing point ).
Intraplate deformation is the folding, breaking, or flow of the Earth's crust within plates instead of at their margins. This process usually occurs in areas with especially weak crust and upper mantle, such as the Tibetan Plateau (Figure 1). Intraplate deformation brings another aspect to plate tectonic theory.
A collision zone occurs when tectonic plates meet at a convergent boundary both bearing continental lithosphere.As continental lithosphere is usually not subducted due to its relatively low density, the result is a complex area of orogeny involving folding and thrust faulting as the blocks of continental crust pile up above the subduction zone.
Fold mountains form in areas of thrust tectonics, such as where two tectonic plates move towards each other at convergent plate boundary.When plates and the continents riding on them collide or undergo subduction (that is – ride one over another), the accumulated layers of rock may crumple and fold like a tablecloth that is pushed across a table, particularly if there is a mechanically weak ...
Compressive stresses can also result in folding of rocks. Because of the large magnitudes of lithostatic stress in tectonic plates, tectonic-scale deformation is always subjected to net compressive stress. [1] Compressive stresses can result in a number of different features at varying scales, most notably including Folds, and Thrust faults.
Two different types of folding may occur at a décollement. Concentric folding is identified by uniform bed thickness throughout the fold, and is necessarily accompanied by detachment or a décollement as part of the deformation that occurs with a thrust fault. [15] Disharmonic folding does not have uniform bed thickness throughout the fold. [16]