Search results
Results from the WOW.Com Content Network
Class B vacuum tube amplifiers are usually operated with grid current (class B 2). The bias voltage source must have low resistance and be able to supply the grid current. [3] When tubes designed for class B are employed, the bias can be as little as zero. Class C amplifiers are biased negatively at a point well beyond plate current cutoff ...
Plate detector circuit with cathode bias. Cathode bias RC time constant three times period of lowest carrier frequency. C L is typically around 250 pF.. In electronics, a plate detector (anode bend detector, grid bias detector) is a vacuum tube circuit in which an amplifying tube having a control grid is operated in a non-linear region of its grid voltage versus plate current transfer ...
The pentode EL84/6BQ5 - 9 pin Noval base tube, that although different enough from the 6V6 not to justify rating it as an equivalent, because of its popularity and ready availability, plus having a close-enough similarity to make it possible, if bias is altered, adapters have been developed commercially to allow an amplifier designed for 6V6 ...
The biasing of a push–pull output stage can be adjusted (at the design stage, usually not in a finished amplifier) between class A (giving best open-loop linearity) through classes AB1 and AB2, to class B (giving greatest power and efficiency from a given power supply, output valves and output transformer).
For transmitting tubes in this system, the second element starts with a dash, a sequentially assigned number, then an optional letter specifying cooling method. For phototubes and photomultipliers, the second element is a sequential number and then a letter code identifying vacuum or gas fill and the type of cathode.
The transmitting tubes TT21 and TT22 have almost identical transfer characteristics to KT88 but a different pinout, and by virtue of their anode being connected to the top cap have a higher plate voltage rating (1.25 kilovolt) and a higher power output capability of 200 watts in class AB1 push–pull.
The purpose of T2 and T3 is to allow back-biasing diode D2 when the amplifier output is at a positive peak (above 39.3 V) and back biasing D4 when the output is at negative peak less than -39.3 V. During the musical peaks from 100 to 400 watts, the +/-40 V rails source no current as all the current comes from the +/-80 V rails.
A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...