enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Mains hum - Wikipedia

    en.wikipedia.org/wiki/Mains_hum

    Mains hum, electric hum, cycle hum, or power line hum is a sound associated with alternating current which is twice the frequency of the mains electricity. The fundamental frequency of this sound is usually double that of fundamental 50/60 Hz , i.e., 100/120 Hz, depending on the local power-line frequency .

  3. Electromagnetically induced acoustic noise - Wikipedia

    en.wikipedia.org/wiki/Electromagnetically...

    The hissing of high voltage transmission lines is due to corona discharge, not magnetism. The phenomenon is also called audible magnetic noise, [1] electromagnetic acoustic noise, lamination vibration [2] or electromagnetically induced acoustic noise, [3] or more rarely, electrical noise, [4] or "coil noise

  4. Switching noise jitter - Wikipedia

    en.wikipedia.org/wiki/Switching_noise_jitter

    In switching-mode power supplies , noise present in the control loop circuitry of the supply causes dislocation in up-slope and down-slope timing of the saw-tooth ripple waveform. As a consequence, the ripple waveform exhibits jitter and noise carried on the ripple also jitters. When this type of supply bias is used to power a system operating ...

  5. Noise (electronics) - Wikipedia

    en.wikipedia.org/wiki/Noise_(electronics)

    Different types of noise are generated by different devices and different processes. Thermal noise is unavoidable at non-zero temperature (see fluctuation-dissipation theorem), while other types depend mostly on device type (such as shot noise, [1] [3] which needs a steep potential barrier) or manufacturing quality and semiconductor defects, such as conductance fluctuations, including 1/f noise.

  6. Clipping (audio) - Wikipedia

    en.wikipedia.org/wiki/Clipping_(audio)

    This extra power can damage the loudspeaker. It may cause damage to the amplifier's power supply or simply blow a fuse. The additional high frequency energy in the harmonics generated by an amplifier operating in clipping can damage the tweeter in a connected loudspeaker via overheating. [2] [3]

  7. Parasitic oscillation - Wikipedia

    en.wikipedia.org/wiki/Parasitic_oscillation

    Bypass capacitors may be put at power supply connections, to provide a low-impedance path for AC signals and prevent interstage coupling through the power supply. Where printed circuit boards are used, high- and low-power stages are separated and ground return traces are arranged so that heavy currents don't flow in mutually shared portions of ...

  8. The Mosquito - Wikipedia

    en.wikipedia.org/wiki/The_Mosquito

    The current device has two settings: the high frequency sound targeted at youth, and another that can be heard by everyone. The range of the sound is 140 feet (43 m) with the sound baffle, and 200 feet (61 m) without. It requires a 24-volt DC or 15-volt AC power supply.

  9. Power supply - Wikipedia

    en.wikipedia.org/wiki/Power_supply

    A simple general-purpose desktop power supply used in electronic labs, with power output connector seen at lower-left and power input connector (not shown) located at the rear Interior of high-end linear power supply with toroidal mains transformer. A power supply is an electrical device that supplies electric power to an electrical load.