Search results
Results from the WOW.Com Content Network
A reed switch has very low resistance when closed, typically as low as 0.05 ohms, whereas the Hall effect sensors can be in the hundreds of ohms. A reed switch requires only two wires whereas most solid-state devices require three wires. A reed switch can be said to require zero power to operate it.
Proximity switches operate by the disturbance of an electromagnetic field, by capacitance, or by sensing a magnetic field. Rarely, a final operating device such as a lamp or solenoid valve is directly controlled by the contacts of an industrial limit switch, but more typically the limit switch is wired through a control relay, a motor contactor ...
(from top) Single-pole reed switch, four-pole reed switch and single-pole reed relay. Scale in centimeters. A reed relay [i] is a type of relay that uses an electromagnet to control one or more reed switches. The contacts are of magnetic material and the electromagnet acts directly on them without requiring an armature to move them.
An early switch operating by this principle was invented by Chester I. Hall of the General Electric Company, with a patent filed in 1921 and approved in 1924.Like the modern infinite switch, Hall's invention used a bi-metallic strip, heated by a constant current, to break a connection after a given period of time.
A Single-Pole, Single-Throw (SPST) mercury switch on millimetre graph paper, device length approximately 1.5 cm Another mercury switch design. A mercury switch is an electrical switch that opens and closes a circuit when a small amount of the liquid metal mercury connects metal electrodes to close the circuit. There are several different basic ...
An inrush current limiter is a device or devices combination used to limit inrush current. Passive resistive components such as resistors (with power dissipation drawback), or negative temperature coefficient (NTC) thermistors are simple options while the positive one (PTC) is used to limit max current afterward as the circuit has been operating (with cool-down time drawback on both).
A high-voltage disconnect switch used in an electrical substation. Such switches are used mostly to isolate circuits, and usually cannot break load current. High-voltage switches are available for the highest transmission voltages, up to 1 million volts. This switch is gang-operated so that all three phases are interrupted at the same time.
High-speed impact takes its toll on all reed valves, with metal valves suffering in fatigue. The physical inertia of reed valves means that they are not as entirely precise in action as rotary valves, a rotary valve engine may run better than a reed valve engine at a small rpm range but the reed valve engine often runs better over a wider rpm ...