enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Standard (timber unit) - Wikipedia

   en.wikipedia.org/wiki/Standard_(timber_unit)

   The timber would be typically called battens (7 inches wide), deals (above 7, usually 9 inches wide) and planks (11 inches wide); boards were under 2 inches thick. [ 3 ] [ 4 ] The standard hundred of the Russian capital of Saint Petersburg was 120 boards which were 12 feet long, 1 1 ⁄ 2 inches thick and 11 inches wide – a volume of 165 ...

3. Deck railing - Wikipedia

   en.wikipedia.org/wiki/Deck_railing

   In between the posts, two 2x4s are attached to the posts with screws for the best connection. The lower board is placed 3.5" from the top of the finish deck to the bottom of the board. The top board is placed with the top at 35" from the deck. Then the vertical 2x2 pressure treated wood balusters are installed spaced regularly every 3.5". Then ...

4. Deal (unit) - Wikipedia

   en.wikipedia.org/wiki/Deal_(unit)

   Deal is an obsolete unit of measurement formerly used in the UK and US to measure wood. [1] In the late 18th and early 19th centuries, a deal originally referred to a wooden board between 12 and 14 feet long that was traded as a maritime commodity. [2] [3]

5. Ship measurements - Wikipedia

   en.wikipedia.org/wiki/Ship_measurements

   Deadweight tonnage (DWT) is a measure of how much weight a ship can carry. [1] [2] [3] It is the sum of the weights of cargo, fuel, fresh water, ballast water, provisions, passengers, and crew. [1] Draft or draught (d) or (T) – The vertical distance from the bottom of the keel to the waterline. Used mainly to determine the minimum water depth ...

6. Speed square - Wikipedia

   en.wikipedia.org/wiki/Speed_square

   Among its basic uses are marking common, hip, valley and hip, or valley jack rafters, laying out stair stringers, determining and marking angles, and making square cuts on boards. Common lines made using a speed square include perpendicular cut marks and Angles definition of an angle for roofs, stairways, and decks. The tool uses a 0° reference.

7. Square (tool) - Wikipedia

   en.wikipedia.org/wiki/Square_(tool)

   Made with a thin steel blade fixed at 90° into a thicker stock that is typically made of wood. The inside face of the stock is sometimes faced with brass to reduce wear. Historically woodworkers would often make their own try squares out of wood. The top of the stock is sometimes at a 45° angle so the square can also be used as a mitre square.

8. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

9. Plank (wood) - Wikipedia

   en.wikipedia.org/wiki/Plank_(wood)

   The wood is categorized as a board if its width is less than 2 + 1 ⁄ 2 in (64 mm), and its thickness is less than 1 + 1 ⁄ 2 in (38 mm). A plank used in a building as a horizontal supporting member that runs between foundations, walls, or beams to support a ceiling or floor is called a joist.