Search results
Results from the WOW.Com Content Network
The damping ratio is a system parameter, denoted by ζ ("zeta"), that can vary from undamped (ζ = 0), underdamped (ζ < 1) through critically damped (ζ = 1) to overdamped (ζ > 1). The behaviour of oscillating systems is often of interest in a diverse range of disciplines that include control engineering , chemical engineering , mechanical ...
The motion is a rapid pitching of the aircraft about the center of gravity, essentially an angle-of-attack variation. The short-period mode is an oscillation with a period of only a few seconds that is usually heavily damped by the existence of lifting surfaces far from the aircraft’s center of gravity, such as a horizontal tail or canard.
The lateral motion had three modes of motion: an aperiodic mode called the spiral mode that could be a divergence or subsidence, a heavily damped aperiodic mode called the roll subsidence, and a short-period oscillation, usually poorly damped, called the Dutch roll mode.
The Q factor is a parameter that describes the resonance behavior of an underdamped harmonic oscillator (resonator). Sinusoidally driven resonators having higher Q factors resonate with greater amplitudes (at the resonant frequency) but have a smaller range of frequencies around that frequency for which they resonate; the range of frequencies for which the oscillator resonates is called the ...
Damped oscillation is a typical transient response, where the output value oscillates until finally reaching a steady-state value. In electrical engineering and mechanical engineering, a transient response is the response of a system to a change from an equilibrium or a steady state. The transient response is not necessarily tied to abrupt ...
Step response of a damped harmonic oscillator; curves are plotted for three values of μ = ω 1 = ω 0 √ 1 − ζ 2. Time is in units of the decay time τ = 1/(ζω 0). The value of the damping ratio ζ critically determines the behavior of the system. A damped harmonic oscillator can be:
This oscillation is called nutation. If the motion is damped, the oscillations will die down until the motion is a steady precession. [3] [4] The physics of nutation in tops and gyroscopes can be explored using the model of a heavy symmetrical top with its tip fixed. (A symmetrical top is one with rotational symmetry, or more generally one in ...
The underdamped response is a decaying oscillation at frequency ω d. The oscillation decays at a rate determined by the attenuation α. The exponential in α describes the envelope of the oscillation. B 1 and B 2 (or B 3 and the phase shift φ in the second form) are arbitrary constants determined by boundary conditions. The frequency ω d is ...