Search results
Results from the WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections .
The most common application for ISO-TP is the transfer of diagnostic messages with OBD-2 equipped vehicles using KWP2000 and UDS, but is used broadly in other application-specific CAN implementations where one might need to send messages longer than what the CAN protocol physical layer allows (8 bytes for CAN, 64 bytes for CAN-FD, and 2048 ...
OBD-II is an improvement over OBD-I in both capability and standardization. The OBD-II standard specifies the type of diagnostic connector and its pinout, the electrical signalling protocols available, and the messaging format. It also provides a candidate list of vehicle parameters to monitor along with how to encode the data for each.
The typical modern TCU uses signals from engine sensors, automatic transmission sensors and from other electronic controllers to determine when and how to shift. [2] More modern designs share inputs or obtain information from an input to the ECU, whereas older designs often have their own dedicated inputs and sensors on the engine components.
Unified Diagnostic Services (UDS) is a diagnostic communication protocol used in electronic control units (ECUs) within automotive electronics, which is specified in the ISO 14229-1. [1]
A controller area network (CAN) is a vehicle bus standard designed to enable efficient communication primarily between electronic control units (ECUs). Originally developed to reduce the complexity and cost of electrical wiring in automobiles through multiplexing, the CAN bus protocol has since been adopted in various other contexts.
A multi-clutch gearbox avoids the difficulties of shifting gear by avoiding the need to shift at all. It operates as a number of separate gearboxes, each one controlled by a separate clutch, interlocked to avoid multiple selection. Selecting a gear is a matter of selecting the appropriate clutch.
The description of Mode 3 DTC parameter data seems to be specific to CAN-bus OBD-II ECUs. Older, pre-2003 OBD-II ECUs (i.e., J1850 VPW/PWM, ISO 9142-2 and Keyword 2000) pack DTC data into multiple OBD-II response packets somewhat differently. --Bruce D. Lightner 17:00, 14 December 2011 (UTC)