Search results
Results from the WOW.Com Content Network
A Bowden cable (/ ˈ b oʊ d ən / BOH-dən) [1] is a type of flexible cable used to transmit mechanical force or energy by the movement of an inner cable relative to a hollow outer cable housing. The housing is generally of composite construction, consisting of an inner lining, a longitudinally incompressible layer such as a helical winding or ...
Instead, the position of the throttle valve (i.e., the amount of air in the engine) is fully controlled by the ETC software via the electric motor. But just opening or closing the throttle valve by sending a new signal to the electric motor is an open loop condition and leads to inaccurate control.
Early cars had a hand lever to control the throttle, either directly, or by controlling an engine speed governor which in turn controlled both the throttle and timing. [6] In 1900 the Wilson-Pilcher car was introduced in Britain which had a hand controlled speed governor, and a foot throttle which could override the action of the governor.
Historically, the throttle pedal or lever acts via a direct mechanical linkage. The butterfly valve of the throttle is operated by means of an arm piece, loaded by a spring. This arm is usually directly linked to the accelerator cable, and operates in accordance with the driver action.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations.
a throttle lever or regulator, which controls the amount of steam entering the cylinders [3]: 75 : 82 a reversing lever or (US term) Johnson bar, which controls the timing of the admission of steam into the locomotive's cylinders. [3]: 65 This is required for two purposes. One is to reverse the locomotive's direction, e.g. when shunting.
The advent of concern about fuel economy and emissions had major impacts on engine design. Some of the trade-offs reduced throttle response. Most new cars employ a drive-by-wire system, which includes electronic throttle control and can itself either reduce or increase throttle response (Depending on whether or not it's being employed on a performance car).
Here, small valves were attached to the original control cables, controlling the flow of oil into an associated actuator connected to the control surface. One of the earliest fittings of a hydraulic boost system was to ailerons on late-war models of the P-38L, removing the need for great human strength to achieve a higher rate of roll.