enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ISO standards for trailer connectors - Wikipedia

   en.wikipedia.org/wiki/ISO_standards_for_trailer...

   7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.

3. Tow hitch - Wikipedia

   en.wikipedia.org/wiki/Tow_hitch

   A tow hitch (or tow bar or trailer hitch in North America [1]) is a device attached to the chassis of a vehicle for towing, or a towbar to an aircraft nose gear. It can take the form of a tow ball to allow swiveling and articulation of a trailer , or a tow pin, or a tow hook with a trailer loop, often used for large or agricultural vehicles ...

4. Three-point hitch - Wikipedia

   en.wikipedia.org/wiki/Three-point_hitch

   The three-point hitch (British English: three-point linkage) is a widely used type of hitch for attaching ploughs and other implements to an agricultural or industrial tractor. [ 1 ] [ 2 ] The three points resemble either a triangle, or the letter A.

5. Taut-line hitch - Wikipedia

   en.wikipedia.org/wiki/Taut-line_hitch

   Book shows a 'linear' Half Hitch to precede a Timber Hitch (that shows should pull at right angle to spar) so can pull lengthwise in ABoK#"1733. The timber hitch and half hitch Killick hitch perhaps best demonstrates the directional force effect as he shows it as the first knot in the chapter right after the previous discussion as context . [5]

6. Semi-trailer aerodynamic device - Wikipedia

   en.wikipedia.org/wiki/Semi-trailer_aerodynamic...

   Semi-trailer aerodynamic devices are devices affixed to semi-trailers, for the purpose of reducing aerodynamic drag caused by air turbulence. The two major types of device in use are trailer skirts (or side skirts ), affixed to the underside of trailers, and trailer tails (or boat tails , or rear fairings ), affixed to the rear.

7. Round turn and two half-hitches - Wikipedia

   en.wikipedia.org/.../Round_turn_and_two_half-hitches

   Variations of this hitch can be made with differing numbers of turns and half-hitches; an example is illustrated below. With additional turns, it becomes a pipe hitch. The Round Turn and Two Half Hitches is named by Steel in 1794. If a spar is small, a round turn is preferable to a single turn. It makes a stronger knot and dissipates the wear.