enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Retaining ring - Wikipedia

   en.wikipedia.org/wiki/Retaining_ring

   A retaining ring is a fastener that holds components or assemblies onto a shaft or in a housing/bore when installed - typically in a groove - for one time use only. Once installed, the exposed portion acts as a shoulder which retains the specific component or assembly.

3. Circlip - Wikipedia

   en.wikipedia.org/wiki/Circlip

   A circlip (a portmanteau of "circle" and "clip"), also known as a C-clip, snap ring, or ', [1] is a type of fastener or retaining ring that consists of a semi-flexible metal ring with open ends that can be snapped into place into a machined groove on a dowel pin or other part to permit rotation but to prevent axial movement.

4. Key (engineering) - Wikipedia

   en.wikipedia.org/wiki/Key_(engineering)

   An additional advantage is a stuck key can be removed from a shaft with a hammer blow, the circular profile will push the key out of the slot, as opposed to a standard key which will need to be pushed axially, or pulled out of its slot. Common applications include machine tools, automotive applications, snowblowers and marine propellers.

5. Split-ring resonator - Wikipedia

   en.wikipedia.org/wiki/Split-ring_resonator

   There is the 1-D Split-Ring Structure with two square rings, one inside the other. One set of cited " unit cell " dimensions would be an outer square of 2.62 mm and an inner square of 0.25 mm. 1-D structures such as this are easier to fabricate compared with constructing a rigid 2-D structure.

6. Starter ring gear - Wikipedia

   en.wikipedia.org/wiki/Starter_ring_gear

   The starter ring gear is most commonly made by forming a length of square or rectangular steel bar into a circle and welding the ends together. This ring is then machined to create flat surfaces of the required inner and outer diameters. The gear teeth are then created using a hobbing tool, followed by processes to chamfer, deburr and clean the ...

7. List of ISO standards 1–1999 - Wikipedia

   en.wikipedia.org/wiki/List_of_ISO_standards_1–1999

   ISO 1179-3:2007 Part 3: Light-duty (L series) stud ends with sealing by O-ring with retaining ring (types G and H) ISO 1179-4:2007 Part 4: Stud ends for general use only with metal-to-metal sealing (type B) ISO 1180:1983 Shanks for pneumatic tools and fitting dimensions of chuck bushings