Ads
related to: pin header female 2mm 40 cm diameter length width
Search results
Results from the WOW.Com Content Network
1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector. A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1] Male pin headers are cost-effective due to their simplicity.
JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors. [ 2 ] [ 3 ] JST connectors are used in many types of products, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers , battery eliminator circuits , 3D printers , and radio controlled servos .
The codes given in the chart below usually tell the length and width of the components in tenths of millimeters or hundredths of inches. For example, a metric 2520 component is 2.5 mm by 2.0 mm which corresponds roughly to 0.10 inches by 0.08 inches (hence, imperial size is 1008).
BTB connectors are divided up into four mounting types: Through-hole technology; Surface-mount technology; Plug-in technology [1]; Solderless stacking mezzanine technology [2]; BTB connectors are selected by considering the mounting method, pin pitch, number of the rows (aka number of the ways), pin length, stacker height etc.
Banana jack connector: male–female pair 2 mm. Various miniature versions of the banana connector have been introduced. One type is 2.6 mm in diameter and about one third the length of the standard connector, and is commonly used in model railway applications. These are substantially more fragile than the larger connectors.
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
A typical SO-239 UHF female, properly hooded, has a difference in impedance from the standard 50 Ohm line impedance of about 35 Ohms. The length of the bump is typically 1 / 2 inch, where the female pin flares to fit over the male pin. This bump can be mitigated by using a honeycomb dielectric in the female pin area.
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
Ads
related to: pin header female 2mm 40 cm diameter length width