enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 10 mm for a M10×1.5 tap), and pitch is the pitch of the thread (1.5 mm in the case of a standard M10 tap) and so the correct drill size is 8.5 mm. This works for both fine and coarse pitches, and also produces an approximate 75% thread.

3. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.

4. Bridgeport (machine tool brand) - Wikipedia

   en.wikipedia.org/wiki/Bridgeport_(machine_tool...

   Machine tapers for tool holding included Morse tapers (on early models) and the R8 taper (a widely used standard that Bridgeport created) on most models. Both Morse and R8 allowed for both collets and solid holders, and a drill chuck could be held by either of the latter. Currently R8 and Erickson #30 Quick Change tool holders are available.

5. Reamer - Wikipedia

   en.wikipedia.org/wiki/Reamer

   Chucking reamers, or machine reamers, are the most common type of reamer used in lathes, drill presses, and screw machines that provide a smooth finish to the hole. They come in a variety of flutes and cuts (e.g. right hand cut, left hand spiral, straight flute) as well as different shank types.

6. Drawbar (machine tool) - Wikipedia

   en.wikipedia.org/wiki/Drawbar_(machine_tool)

   The drawbar pull is an important component that allows the milling machine to keep the tool in place while it’s being used. The force from the drawbar pull supplied to the tool has to be just right because not enough force would cause the tool to wobble leading to inaccuracy, and too much force would apply excessive stress, leading to shorter tool life.

7. Tap wrench - Wikipedia

   en.wikipedia.org/wiki/Tap_wrench

   The clamp is opened to insert the tool and then tightened down against the tool to secure it. This type of tap wrench is used with larger taps and where there is room to turn a larger wrench. [1] A T-handle is more compact. This type of wrench uses a collet to secure the tool. The collet design has two pieces: a threaded "nosecap" and four ...