enow.com Web Search

  1. Ads

    related to: how to stop water hammer when flushing toilet tank drain seal

Search results

  1. Results from the WOW.Com Content Network
  2. How To Clean A Toilet Tank To Prevent Rust And Mildew ... - AOL

    www.aol.com/clean-toilet-tank-prevent-rust...

    Once the water supply has been turned off, Adams says you'll need to flush the toilet until the tank drains so you're able to give the interior a good scrub with it empty.

  3. Water hammer - Wikipedia

    en.wikipedia.org/wiki/Water_hammer

    Hydraulic shock (colloquial: water hammer; fluid hammer) is a pressure surge or wave caused when a fluid in motion is forced to stop or change direction suddenly: a momentum change. It is usually observed in a liquid but gases can also be affected.

  4. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    The visible water surface in a toilet is the top of the trap's water seal. Each fixture drain, with exceptions, must be vented so that negative air pressure in the drain cannot siphon the trap dry, to prevent positive air pressure in the sewer from forcing gases past the water seal, and to prevent explosive sewer gas buildup.

  5. Vacuum breaker - Wikipedia

    en.wikipedia.org/wiki/Vacuum_breaker

    A vacuum breaker is a device that prevents water from being siphoned backward in a direction it is not desired to go. They are commonly placed on a bibcock valve or toilet or urinal flush valve, in which application they can prevent hose or drainage water from back-siphoning into the public drinking water system. This prevents contamination ...

  6. Trap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Trap_(plumbing)

    Water seal in drain pipe under a sink. Water enters at right, fills the trap, and continues left. Inverted siphoning occurs below the line "A". Examples of traps. In plumbing, a trap is a U-shaped portion of pipe designed to trap liquid or gas to prevent unwanted flow; most notably sewer gases from entering buildings while allowing waste ...

  7. Backflow prevention device - Wikipedia

    en.wikipedia.org/wiki/Backflow_prevention_device

    Backflow prevention device. The simplest, most reliable way to provide backflow prevention is to provide an air gap.An air gap is simply an open vertical space between any device that connects to a plumbing system (like a valve or faucet) and any place where contaminated water can collect or pool.

  8. Check valve - Wikipedia

    en.wikipedia.org/wiki/Check_valve

    Undetected, water hammer can rupture pumps, valves, and pipes within the system. [9] The flapper valve in a flush-toilet mechanism is an example of this type of valve. Tank pressure holding it closed is overcome by manual lift of the flapper. It then remains open until the tank drains and the flapper falls due to gravity.

  9. Ballcock - Wikipedia

    en.wikipedia.org/wiki/Ballcock

    When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.

  1. Ads

    related to: how to stop water hammer when flushing toilet tank drain seal